Funk-Bewegungsmelder - ABUS Security-Center
Funk-Bewegungsmelder - ABUS Security-Center
Funk-Bewegungsmelder - ABUS Security-Center
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Flat wall<br />
installation<br />
Wall tamper contact<br />
To use the wall tamper contact, proceed as follows:<br />
1. Open the hole on the rear of the sensor. Make sure that<br />
the opening is large enough for the head of the tamper<br />
switch.<br />
2. Mark the position of the hole on the wall where the<br />
sensor is to be fitted. Drill a hole on the mark, then insert<br />
a suitable wall plug and insert a screw (M3). The screw<br />
head must not be more than 2.5 mm from the wall<br />
surface.<br />
3. Fasten the rear housing cover to the wall, making sure<br />
the head of the screw protrudes through the opening<br />
and presses against the tamper switch after the sensor<br />
housing is attached (see illustration). If this is not the<br />
case, then the screw must be unscrewed further as<br />
necessary.<br />
22<br />
Vertical corner<br />
installation