Graco JUNIOR MINI - JUNIOR MINI mode d'emploi
Graco JUNIOR MINI - JUNIOR MINI mode d'emploi
Graco JUNIOR MINI - JUNIOR MINI mode d'emploi
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
18<br />
I. Attach the lap belt to the two rear-facing seat belt hooks locate at the<br />
front bottom of the safety seat.<br />
II. Pull the diagonal belt to suitable length to get around the back of the<br />
seat, and then attach the diagonal belt to the rear-facing seat belt hooks<br />
that locate at the back top of the seat.<br />
Fig. 16.1 Diagonal belt<br />
Fig. 16.2 Lap belt<br />
• Attaching the seat belt to the hooks (Fig.17).<br />
5 Push the car seat down and against the vehicle seat. At the same time, pull<br />
the seat belts to the direction so that the car seat is tightly and securely fitted<br />
(Fig.18).<br />
6 Recheck if the car seat is securely fitted after completing the above installations.<br />
(Check by moving the car seat back and forth)<br />
Make sure that both the lap belt and diagonal belt are not twisted or folded,<br />
and will not prevent the vehicle seat belt to be fully and rightly functioned<br />
(Fig. 19).<br />
Installation to the Vehicle<br />
(Forward Facing Mode,for child between 9~18kg)<br />
Note that this <strong>mode</strong> must ONLY be used for child weighing between<br />
9-18 kg (approximately between 1-4 years old)<br />
lt is highly recommended to have the car seat installed at the back seats of<br />
your vehicle. (Fig. 20)<br />
1 Pull the vehicle seat belt to suitable length then follow the following steps<br />
to secure the safety seat.<br />
I. Pull the vehicle seat belt through one front belt cover (Fig. 21)<br />
II. Open the seat pad cover and pull the vehicle seat belt through (Fig. 22).<br />
III. Pass through the vehicle seat belt to the other front belt cover<br />
(Fig. 23).<br />
IV. Secure the vehicle seat belt until a “CLICK“ sound is heard (Fig. 24).<br />
2 Push the car seat down against the vehicle seat. At the same time, pull the<br />
seat belt to the direction as the figure shown so that the car seat is tightly<br />
and securely fitted (Fig. 25) – Push down.