Battery powered energizer installation instructions - Gallagher.eu

English
10
2. Connect to earth system:
Using Lead-out Cable G6270 remove 5cm (2”) of plastic coating from one end of
the cable and attach to the green terminal on the energizer. Attach the cable to
the earth system by removing 10cm (4”) of insulation from the cable at each Earth
Stake, then clamp the exposed wire to each stake using an Earth Clamp G8760.
Tighten the clamp.
For maximum performance from your energizer, the earth (ground) system must
be correctly installed. Use 3 galvanised earth pegs (G619). Earth pegs, at least 2
metres (6½ft) long, should be spaced 3 metres (10ft) apart.
For further instructions on the earth system see “How to install earth system”
section.
3. Connect the fence
Connect energizer’s red terminal to the fence using Leadout
Cable G6270: remove 5cm (2”) of plastic coating from
one end of the cable and attach to the red terminal on the
energizer. Attach the other end of the cable to the fence
using a Joint Clamp G6030.
For instructions on fence installation refer to “How to
install the fence” section.
4. Connect the battery
Connect the battery leads from the energizer to the
battery: red lead to the (+) terminal of battery, black
lead to the (-) terminal of battery. Use external 12V deep
cycle lead acid rechargeable battery. Do not use nonrechargeable
batteries.
During charging, place lead acid batteries in a well-ventilated area.
WARNING: For B75, this turns the energizer on.
When battery is flat (voltage drops to approx. 11.5V), the energizer slows to half
speed to conserve power.
Use external 12V deep cycle rechargeable battery (marine type).
Battery life (using one fully charged 12v 60 ampere hour battery)
High Power/Standard Pulse
(Days)
Low Power/Maximum
Save mode (Days)
B75 34 -
B160 15 50
B260 10 30
To
battery
Green
To
earth
For Solar Systems test the battery every 12 months because rechargeable
batteries can lose storage capacity over time.
Red
To
fence