ATH-Heinl Bedienungsanleitung Hubtisch T15

When selecting the installation site, the guidelines and instructions of the accident prevention regulations and
the workplace regulations must be observed in addition to the ground conditions.
If the unit is to be installed on a floor slab, its sufficient load-bearing capacity must be checked. In general, it
is recommended that a building expert be consulted for an assessment when installing the machine on floor
ceilings.
The machine is only to be installed and used inside closed rooms. It does not have appropriate safety equipment
(e.g. IP protection, galvanized design) for outdoor use.
Temperature 5 - 50°C
Sea level
< 1500m
Humidity 50% at 40°C - 90% at 20°C
Location Minimum distances
A1
B1
A2
A1
A2
B1
Min. 700 mm
Min. 700 mm
Min. 700 mm
The power connection and the earthing cable must be connected in the form of a plug-in device (socket and
plug) or a fixed connection.
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
Release date: 16.07.2024 / Product manufacturer ATH-Heinl GmbH & Co. KG
63