Operating instructions - IMI Cornelius

Weitere Magazine

Empfehlungen

Info

Cleaning <strong>instructions</strong> for the smartDRAFT Tap Wipe with a damp clean soft cloth if required. Do not use soap. Do not use dishwasher! Technical specifications smartDRAFT Tap Dimensions in mm Height 186 Width 124 Length 346 Dispatch weight in kg 1.75 Flow (covers all beer types with 4.5-5.5 g CO 2 /l in a temperature range of 2-8 °C 1.6-2.0 l/minute at pre-set pressure of 0.9 bar Micro Matic A/S assumes no responsibility for errors, if any, in catalogues, brochures, and other printed matter. Micro Matic A/S reserves the right to modify its products without prior notice, including already ordered products, if this can occur without changing already stated specifications. All right reserved. smartDRAFT and its components are protected by several patents. See also smartDRAFT Cooler manual.
Trouble shooting for bar staff Problem Reason Solution No beer flow, when dispense handle is pulled Tap not connected correctly One-way beer line has been used once One-way beer line is defective Tap is defective Beer is too warm No beer in the keg No CO 2 in the keg Open and close tap cover again Replace one-way beer line Replace one-way beer line Contact brewery See problem „beer is too warm“ below Replace keg Replace keg and contact brewery Beer is foaming Handle is not opened completely Open handle completely Handle is opened/closed too slowly Glass is too warm Beer is too warm One-way beer line is defective Open/close handle fast in one move Cool glass with cold water before dispensing See problem „beer is too warm“ below Replace one-way beer line Too less foam Beer glass is not clean Clean glass with beer glass cleaner No CO 2 in the keg Beer too cold Replace keg and contact brewery See problem „beer is too cold“ below Beer is too warm Keg is not prechilled Take prechilled keg Cooler is/was not connected to electricity Cooler is not adjusted correctly Cooler is defective Cool down keg in cooler (~ 3 hours) Keep cooler connected when a keg is connected Contact brewery Contact brewery Beer is too cold Temperature of prechilled keg too low Check temperature prechiller Cooler is not adjusted correctly Contact brewery CO 2 is leaking Tap not connected correctly Open and close tap cover again No one-way beer line installed One-way beer line is defective Tap is defective Keg is defective Install one-way beer line Replace one-way beer line Contact brewery Replace keg and contact brewery Beer is leaking One-way beer line is defective Replace one-way beer line Only gas is coming out, when handle is pulled Gasket in keg defective Keg is empty One-way beer line has already been used once Replace keg and contact brewery Replace new keg Install new one-way beer line ENGLISH
Seite 1 und 2: Operating instructions
Seite 3 und 4: The upper part must be completely o
Seite 5 und 6: Remove the drip tray by lift up an
Seite 7: Make sure that the green light is o
Seite 11 und 12: Der obere Teil muss dabei komplett
Seite 13 und 14: Entfernen Sie die Tropfschale, inde
Seite 15 und 16: Achten Sie darauf, dass die grüne
Seite 17: Fehlersuchanleitung für die Bedien

Operating instructions - IMI Cornelius

Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.

Template löschen?

Als Template speichern?