Bedienungsanleitung - T+A Elektroakustik

���� ���� A and ���� B (Loudspeaker terminals)
Two pairs of loudspeakers can be connected to the
amplifier (SPEAKER ���� A and SPEAKER ���� B). The
impedance of each speaker must not be lower than 4 Ω
(according to DIN).
The output stages are designed to cope with a minimum
load of 2 Ω but continuous operation at very high volume
produces high currents in the power output stages which
can lead to overheating. This in turn trips the protective
circuit which switches the amplifier off automatically.
It is important to ensure that the terminal clamps are
firmly screwed down, and that no short-circuits can occur
through wire "whiskers" at the terminals.
A selection of excellent cable is available as accessories
matching to the � units. Please ask your �
specialist dealer.
Note:
If the loudspeakers are to be used in countries outside
the EU the red/black stoppers can be removed from the
loudspeaker terminals. The speakers can then be
connected using banana plugs.
The stoppers are simply a push-fit in the terminals, and
can be prised out from the rear using a suitable tool such
as a knife blade.
27
Note:
The power amplifier can be used as a normal stereo
power amplifier. It can also work in various other modes
of operation, such as bi-wiring and bi-amping. The wiring
arrangements are shown in separate wiring diagrams.