Adabas Console Messages †ADAN* & ADACM*‡ - Software AG ...

Adabas Console Messages (ADAN* & ADACM*)
ADAN46 Function not executable
16
Explanation The requested function/command was valid but could not be executed. This message
may occur alone or preceded by one of the following ADAN46 messages, which
provide reasons why the current nucleus status does not allow the requested function:
ADAN46
Message
Text
Online
process
running
Not yet
supported by
Cluster
Services
Failed to
acquire
global
parameter
lock
Explanation Action
The ADAEND request was rejected
because an online reorder or online
invert process is running.
The version of Adabas Cluster
Services you are running does not
support the requested function. The
function is supported only by a
nucleus running in noncluster mode.
An error occurred when a nucleus
running in Adabas cluster mode
attempted to acquire the global
parameter lock in order to change a
global Adabas parameter. The
parameter was not changed.
Request ADAEND again after
the online process finishes.
Consider using HALT to stop
the online process and shut
down the nucleus.
Contact your Software AG
technical support
representative.
In addition, if User Exit 2 is attempting to switch from one dual log to another and if the
data set to be overwritten is full, this error will be issued.
Action Wait a minute or two, then retry the command. If the message recurs, advise your
system support personnel. If the message recurs while trying to issue a command in
response to a previous error, make a note of that error and the related information for
future reference.
ADAN47 Online DUMP-DB is running, function not executed
Explanation A SYNCC, ADAEND, HALT, or CANCEL operator command was issued, but is not
permitted during the current online save operation.
Action Wait until the online save has ended, then retry the command.
Overview of Messages