01.03.2013 Views

Renault Immobiliser unlock. Decoder/UCH information Megane ...

Renault Immobiliser unlock. Decoder/UCH information Megane ...

Renault Immobiliser unlock. Decoder/UCH information Megane ...

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>Renault</strong> Clio 2 (Radio aerial on front of roof)<br />

<strong>Renault</strong> <strong>Immobiliser</strong> <strong>unlock</strong>. <strong>Decoder</strong>/<strong>UCH</strong> <strong>information</strong><br />

<strong>Megane</strong> & <strong>Megane</strong> Scenic We need to know what colour the fuse box is.<br />

It is located under a cover to right of steering wheel and will be Black or Blue<br />

If it is Blue like this one (left) then we need the engine ECU from under the<br />

bonnet We will extract the necessary code and return with a small, ready<br />

programmed, Bypass unit which needs to fitted to the plugs on top of this fuse<br />

box. Instructions are provided.<br />

_ _ _ _ _ _ _ _<br />

If it is Black then we can work from a number inside<br />

your key.<br />

The number is either on a white label or engraved<br />

into the black plastic key head. The number begins<br />

with letter ‘S’<br />

We will supply a Bypass unit ready programmed<br />

which is fitted to the plugs on top of this unit.<br />

Instructions provided<br />

We can either supply a ready<br />

programmed Bypass unit or Pin<br />

Entry Pod if there is a code number<br />

inside the ignition key. The number<br />

is either on a label on fob circuit<br />

board or sprayed inside the black<br />

plastic key head (see left) in UV<br />

sensitive ink. The PEP sits on the vehicle diagnostic socket and can<br />

be left in place permanently. The Bypass is fitted to the plugs going<br />

to the <strong>UCH</strong> in passenger footwell. Instructions are supplied.<br />

You could also remove the <strong>UCH</strong> and send it to us. We will mount the bypass internally and return it<br />

_ _ _ _ _ _ _ _<br />

<strong>Renault</strong> Clio ( early)<br />

The early Clio <strong>Decoder</strong> unit is located<br />

behind dash..about opposite where drivers<br />

right knee would be. It just pulls off.<br />

If this unit (see left) is not there then look<br />

for this one (single plug decoder) located<br />

further over towards the door and higher<br />

Clio <strong>UCH</strong> unit<br />

Single Plug decoder


<strong>Renault</strong> Kangoo/Master/Movano/Vivar<br />

<strong>Decoder</strong> Unit<br />

All these vans use the same decoder<br />

unit (Vehicles up to about 02)<br />

These vehicles can be disarmed<br />

using the Pin Entry Pod or send this<br />

nit to us and we will mount the<br />

Bypass internally<br />

On the Kangoo it is located behind the Speedo. Remove the screws from<br />

speedo assembly and pull the<br />

instrument pack forward. The<br />

<strong>Decoder</strong> unit can be seen in bottom left hand corner.<br />

On the Master etc it is usually located under dash behind steering column<br />

For more <strong>information</strong> on the PIN ENTRY POD see website<br />

<strong>Renault</strong> Espace<br />

_ _ _ _ _ _ _ _<br />

<strong>Decoder</strong> unit is mounted behind this panel see picture<br />

Kangoo<br />

Master etc 1<br />

Espace pre ‘97<br />

If yours is the later Espace IV then we need this unit from passenger side. On<br />

the Espace IV the immobiliser warning<br />

light can’t be extinguished<br />

Espace Body control unit

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!