shifters - Paradise Road Speed and Custom

U-cut-to-Fit cruise control cables
Lokar Cruise Control Cable is for use with “Rostra” Control kits. Kit includes 4'
stainless outer housing designed with a specially extruded liner for extended
life of the cable and 5' of stainless inner wire, which replaces the black plastic
cable in Rostra Kits . Cables are “U-Cut-to-Fit” inside and outside of firewall . All
billet aluminum fittings and stainless hold down clamp and mounting bracket .
Mount cable to carburetor with Lokar’s Stainless Carburetor Bracket and Return
Springs, Part No . SRK-4000 .
Part no. Description
CC-1600U Carbureted Cruise Control Cable - Black
CC-1601HT Carbureted Cruise Control Cable - Stainless
CC-1602U Tuned-Port Cruise Control Cable - Black
CC-1603HT Tuned-Port Cruise Control Cable - Stainless
Rostra control
threaded steel stud
toll Free 1-877-469-7440
cc-1601Ht
cc-1602U
Anchor-tight® Headlight Braid
No, this is not just another headlight conduit! This is Lokar’s design technology
for “U-Cut-to-Fit”, non-kinking stainless steel headlight braid . Designed with
threaded steel studs to insure that you won’t experience any of the typical separation
between braid and fitting that shows unsightly wires out in the open .
Pull, tug or bump your headlight braid and it will stay in place, leaving you
with protected wires and a clean set up . Kit comes complete with two 14" flexible
braided stainless steel Teflon-lined housings, threaded STEEL studs, billet
aluminum fittings, aluminum grill shell washers and four 26" headlight wires .
Part no. Description
HL-1900 Stainless Headlight Braid
exterior
Products
61