UBBINK SOLAR IN-ROOF SYSTEM Installation guide
UBBINK SOLAR IN-ROOF SYSTEM Installation guide
UBBINK SOLAR IN-ROOF SYSTEM Installation guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7 Slate roofs<br />
■ Slate roofs require that the Ubiflex<br />
flashing is positioned at the top of<br />
the system.<br />
■ Position the 400mm wide Ubiflex<br />
approximately 200mm above the<br />
in-roof roll, with 20mm extending<br />
past the top batten. Unroll across<br />
the whole width of the PV field,<br />
screwing to the batten at the top<br />
edge of the roll.<br />
■ Fold the top edge back by 20mm.<br />
■ Bend both left and right hand<br />
sides back 20mm in the same<br />
manner along two thirds of<br />
the height.<br />
■ Bend the top left and right<br />
extremities in the same manner.<br />
■ Dress the bottom 200mm<br />
carefully over the in-roof roll.<br />
10 I 11 Ubbink - Solar energy systems<br />
200mm<br />
The above images are representative and may change accordingly.<br />
20mm<br />
20mm