Kellems® Wire Management Products
Kellems® Wire Management Products
Kellems® Wire Management Products
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Hose Containment Grips Kellems ® <strong>Wire</strong> <strong>Management</strong> <strong>Products</strong><br />
Kellems ® <strong>Wire</strong> <strong>Management</strong> <strong>Products</strong><br />
Hose Containment Grips<br />
WARNING!<br />
It is important that you read all breaking strength,<br />
safety and technical data relating to this product<br />
on pages T-42 through T-43 .<br />
T-58<br />
Types of Attachment<br />
The five attachment methods shown below provide<br />
unlimited flexibility of attachment to meet any<br />
condition .<br />
Type E<br />
Double Eye Grip, used where fastening is made with<br />
eyebolts or similar anchor terminations .<br />
Type A<br />
Single Eye Grip, used where fastening MUST be made<br />
from one point .<br />
Type U<br />
Universal Bale Grip, used to fasten around a structure or<br />
closed eye .<br />
Type Y<br />
Threaded bolt (⁵⁄₁₆-18 x 1½" long), used to fasten through<br />
drilled holes in plate .<br />
Type F<br />
Split fitting to fit AN-818 nuts . Fitting is positioned over<br />
nut and located with internal flange . A hose clamp is<br />
furnished and required to hold the fitting in correct<br />
position .<br />
Note: It should be emphasized that Kellems ® Hose Containment Grips are not to be used as a pressure reinforcing device for hose systems. These grips are<br />
custom made. Consult Technical Services for details.<br />
Kellems Hose Containment Grips are used on high pressure, flexible hose lines to prevent the hose from whipping<br />
violently in the event of hose failure at the fitting . These grips will prevent serious injury to personnel and damage<br />
to equipment by holding the hose in place in the event of hose failure .<br />
Kellems patented Hose Containment Grips are made of stainless steel with double weave mesh construction for<br />
high strength and come complete with hose clamps .<br />
Kellems Hose Containment Grips are supplied in diameters, length and attachments to meet individual requirements .<br />
Contact the Wiring Device-Kellems factory for specific information . These grips help meet OSHA Federal Register<br />
1926-302 (b), 1926-603 (9), (10), JIC H-1-1973 (H13 .11) and JIC P-1-1975 (P11 .34) requirements .<br />
www.hubbell-wiring.com<br />
Dimensions in Inches (cm)