KX-TDA100 Installation Manual - Telephone Wreckers Pty Ltd

More documents

Recommendations

Info

1.4 Specifications Extension Connection Cable SLT 1-pair wire (T, R) 28 Installation Manual DPT 1-pair wire (D1, D2) or 2-pair wire (T, R, D1, D2) APT 2-pair wire (T, R, D1, D2) PT-interface CS 1-pair wire (D1, D2) DSS Console and Add-on Key Module 1-pair wire (D1, D2) Dimension KX-TDA100 334 mm (W) × 390 mm (H) × 270 mm (D) Weight (when fully mounted) KX-TDA200 430 mm (W) × 415 mm (H) × 270 mm (D) KX-TDA100 Under 12 kg KX-TDA200 Under 16 kg
1.4.2 Characteristics Terminal Equipment Loop Limit PT: KX-T7600 series: 90 Ω; all other DPTs/APTs: 40 Ω SLT: 60 Ω including set Doorphone: 20 Ω Minimum Leakage Resistance 15 000 Ω minimum Maximum Number of Extension Instruments per Line CS: 130 Ω; PT-interface CS: 65 Ω 1 for PT or SLT 1.4 Specifications 2 by Parallel or eXtra Device Port connection of an APT/DPT and an SLT 3 by Digital eXtra Device Port connection of two DPTs and an SLT Ring Voltage 75 Vrms at 20 Hz/25 Hz depending on the Ringing Load Trunk Loop Limit 1600 Ω maximum Hookswitch Flash/Recall Timing Range 24 ms to 2032 ms BRI Cards Internal ISDN Mode Supply Voltage: 40 V Power Supply: 4.5 W per 1 line, 10 W per 4 lines (BRI4) 4.5 W per 1 line, 20 W per 8 lines (BRI8) Power Supply Method: Phantom Power Supply Door Opener Current Limit 24 V DC/30 V AC, 1 A maximum External Relay Current Limit 24 V DC/30 V AC, 1 A maximum External Sensor Current Limit Power to the external sensor is provided from the EIO4 card and must be grounded through the EIO4 card. For the connection diagram, refer to "2.6.4 EIO4 Card". The Hybrid IP-PBX detects input from the sensor when the signal is under 100 Ω. Paging Terminal Impedance 600 Ω MOH (Music on Hold) Terminal Impedance 10 000 Ω Installation Manual 29
Page 1 and 2: KX-TDA100 Model KX-TDA200 Thank you
Page 3 and 4: System Components Table Other Cards
Page 5 and 6: Important Safety Instructions SAFET
Page 7 and 8: Precaution Keep the unit away from
Page 9 and 10: The KX-TDA100E/KX-TDA200E, the KX-T
Page 11 and 12: Precautions for Users in the United
Page 13 and 14: Table of Contents 1 System Outline.
Page 15 and 16: 3 Guide for the KX-TDA Maintenance
Page 17 and 18: Section 1 System Outline This secti
Page 19 and 20: Parallelled Telephone Features 1.1
Page 21 and 22: 1.2.2 System Connection Diagram Tru
Page 23 and 24: 1.2 Basic System Construction *1 Th
Page 25 and 26: Model No. Model Name Description KX
Page 27: 1.4 Specifications 1.4.1 General De
Page 31 and 32: 1.4 Specifications The following nu
Page 33 and 34: Maximum Terminal Equipment 1.4 Spec
Page 35 and 36: CS (1 unit) 4 PT-interface CS (1 un
Page 37 and 38: Section 2 Installation This section
Page 39 and 40: 2.1 Before Installation 3. Avoid us
Page 41 and 42: 2.2.2 Names and Locations Inside Vi
Page 43 and 44: Closing the Front Cover 2.2 Install
Page 45 and 46: 2.2 Installation of the Hybrid IP-P
Page 47 and 48: 2. Turn the 4 screws anticlockwise
Page 49 and 50: 2.2.6 Backup Batteries Connection 2
Page 51 and 52: 2.2 Installation of the Hybrid IP-P
Page 53 and 54: Handling of the Cables 2.2 Installa
Page 55 and 56: 2.2.8 Types of Connectors Connector
Page 57 and 58: 2.2.9 Attaching a Ferrite Core A fe
Page 59 and 60: 2.2.10 Fastening Amphenol Type Conn
Page 61 and 62: 2.2.11 Wall Mounting (KX-TDA200) CA
Page 63 and 64: 2.2.12 Wall Mounting (KX-TDA100) CA
Page 65 and 66: 2.2.13 Floor Standing (KX-TDA200 On
Page 67 and 68: Make sure that the surface behind t
Page 69 and 70: Outside Installation Trunk 2.2 Inst
Page 71 and 72: 2.3 Installation of the Main Proces
Page 73 and 74: 2.3.2 MEC Card Function 2.3 Install
Page 75 and 76: 2.4 Installation of the Trunk Cards
Page 77 and 78: 2.4.2 DID8 Card Function 8-port DID
Page 79 and 80:
2.4.3 CID/PAY8 Card Function 2.4 In
Page 81 and 82:
2.4.5 E&M8 Card Function 8-port E &
Page 83 and 84:
LED Indications Indication Colour D
Page 85 and 86:
Pin Assignments RJ45 Connector for
Page 87 and 88:
2.4.7 E1 Card Function 1-port E1 tr
Page 89 and 90:
BNC (coaxial) Connector (RX) 1 2 LE
Page 91 and 92:
Switch Settings Switch Type Usage a
Page 93 and 94:
Maximum Cabling Distance of S0 Bus
Page 95 and 96:
Switch Settings Switch Type Usage a
Page 97 and 98:
Maximum Cabling Distance of Extensi
Page 99 and 100:
Pin Assignments RJ45 Connector for
Page 101 and 102:
2.4.11 IP-GW4 Card Function 2.4 Ins
Page 103 and 104:
2.4.12 IP-GW4E Card Function 2.4 In
Page 105 and 106:
2.4.13 IP-GW16 Card Function 2.4 In
Page 107 and 108:
2.5 Installation of the Extension C
Page 109 and 110:
2.5.2 DHLC8 Card Function 2.5 Insta
Page 111 and 112:
Page 113 and 114:
Pin Assignments Amphenol Connector
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
2.5.7 SLC16 and MSLC16 Cards Functi
Page 121 and 122:
2.5.8 IP-EXT16 Card Function 2.5 In
Page 123 and 124:
2.6 Installation of the Other Cards
Page 125 and 126:
Pin Assignments 8-pin Terminal Bloc
Page 127 and 128:
Pin Assignments 8-pin Terminal Bloc
Page 129 and 130:
2.6.4 EIO4 Card Function 4-port ext
Page 131 and 132:
Connection Diagram for External Sen
Page 133 and 134:
2.6.6 MSG4 Card Function 4-channel
Page 135 and 136:
Page 137 and 138:
2.7.2 Parallel Connection of the Ex
Page 139 and 140:
2.7 Connection of Extensions 2.7.3
Page 141 and 142:
With KX-T7600E Series DPT Using a M
Page 143 and 144:
Connecting to a Master DPT To DLC8/
Page 145 and 146:
2.8 Connection of DECT Portable Sta
Page 147 and 148:
2.8.2 Procedure Overview 2.8 Connec
Page 149 and 150:
2.8.3 Site Planning 2.8 Connection
Page 151 and 152:
CS Coverage Area 2.8 Connection of
Page 153 and 154:
2.8.4 Before Site Survey Use the KX
Page 155 and 156:
1 2 3 4 Setting and Installing the
Page 157 and 158:
2.8.5 Site Survey Using the KX-TCA2
Page 159 and 160:
3. Repeat the steps 1 and 2 for oth
Page 161 and 162:
2.8.6 After Site Survey 2.8 Connect
Page 163 and 164:
Using a DHLC/DLC Card Refer to the
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
PS Termination Confirm the followin
Page 171 and 172:
2.8.8 Wall Mounting 2.8 Connection
Page 173 and 174:
2.9 Connection of 2.4 GHz Portable
Page 175 and 176:
2.9.2 Procedure Overview 2.9 Connec
Page 177 and 178:
2.9.3 Site Planning 2.9 Connection
Page 179 and 180:
CS Coverage Area 2.9 Connection of
Page 181 and 182:
2.9.4 Before Site Survey Setting an
Page 183 and 184:
2.9.5 Site Survey 2.9 Connection of
Page 185 and 186:
2.9 Connection of 2.4 GHz Portable
Page 187 and 188:
2.9.6 After Site Survey 2.9 Connect
Page 189 and 190:
Using a DHLC/DLC Card Refer to the
Page 191 and 192:
Registering the PS 2.9 Connection o
Page 193 and 194:
Setting the System Lock 2.9 Connect
Page 195 and 196:
PS Termination Confirm the followin
Page 197 and 198:
Reference for Wall Mounting Please
Page 199 and 200:
2.10 Connection of Doorphones, Door
Page 201 and 202:
2.11 Connection of Peripherals 2.11
Page 203 and 204:
For connecting a printer/PC with a
Page 205 and 206:
2.12 Power Failure Connections 2.12
Page 207 and 208:
Using BRI Card 2.12 Power Failure C
Page 209 and 210:
2.13 Starting the Hybrid IP-PBX 2.1
Page 211 and 212:
2.13 Starting the Hybrid IP-PBX To
Page 213 and 214:
Section 3 Guide for the KX-TDA Main
Page 215 and 216:
3.2 Connection 3.2.1 Connection Ser
Page 217 and 218:
3.3 Installation of the KX-TDA Main
Page 219 and 220:
3.3 Installation of the KX-TDA Main
Page 221 and 222:
Section 4 Troubleshooting This sect
Page 223 and 224:
PROBLEM PROBABLE CAUSE SOLUTION The
Page 225 and 226:
(Continued from the previous page.)
Page 227 and 228:
PROBLEM PROBABLE CAUSE SOLUTION PS
Page 229 and 230:
4.1.5 Troubleshooting by Error Log
Page 231 and 232:
List of Errors and Solutions 4.1 Tr
Page 233 and 234:
Error Code Error Message PROBABLE C
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Section 5 Appendix Installation Man
Page 243 and 244:
5.1.2 Version 2.0 New Options Syste
Page 245 and 246:
Index Installation Manual 245
Page 247 and 248:
Installation of the Main Processing
Page 249 and 250:
Index Installation Manual 249
show all

KX-TDA100 Installation Manual - Telephone Wreckers Pty Ltd

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?