installation manual - Auton Motorized Systems

Recommendations

Info

The Authority in Custom Motorized Lifts INSTALLATION MANUAL Dream machine Installation Guide Step 1: Testing Please read the manual before operating. Test before Installation 1. Place unit on a hard flat level surface with enough clearance to operate. 2. Remove side handle bars before plugging into power source. The front handles may be left in place or removed. 3. Plug into an 110V AC convenience outlet. (A surge protector is highly recommended) 4. Make sure nothing will interfere with it’s operation . 5. Press the UP button on the wireless remote control. The unit will slide out, pivot up and extend to the full up position. (Units with the swivel options will only swivel once it’s in the fully extended up position and will only retract when centered) Caution: Do Not under any circumstances exceed the recommended weight capacity. Do Not attempt to modify or alter the unit. Doing so will void your warranty and place the unit and attached load at risk. The unit must be installed on a hard flat level surface, if placed on carpet a board with a minimum thickness of 3/8” must be placed underneath the unit. Do Not adjust limit on the motor itself unless instructed by one of our technicians, Using a power tool to adjust the limits will void the warranty. Installation support: We take great pride in manufacturing the best lift systems in the world. Our design and production techniques enable simple installation. In the event that you require assistance, do not hesitate to contact one of our technicians. We will be happy to answer your questions and resolve any problems you encounter during the installation process. Phone Support: 661-257-9282, exrt: tech@auton.com WWW.AUTON.COM 29102 Hancock Pkwy | Valencia, California 91355 Phone: 661-257-9282 | Fax: 661-295-5638 E-mail: tvlifts@auton.com
Step 2: Setting Limits Setting Up limit Note: Up limit has been preset at factory for full travel. Use the hand held programming switch to set Up limits ONLY if you want to change or adjust the limit setting. 1. Unplug existing “switch lead” from the post’s control box. 2. Plug “programming switch” into control box. 3. Use the “arrows” on the switch to raise the lift to the desired up location. 4. Press “S”, release, and then press “1”. You’ve set the up limit stop. 5. After setting limit stop point, DO NOT use the arrow keys to operate the mechanism. Press and hold #1 for Up & press and hold #2 for down. 6. Unplug programming switch from control box and replace with original switch lead. Step 3: Installation Installation & Setup Instructions Programming Switch 1. After testing the unit mount the TV to the mounting brackets. 2. Route the power cord and other cables going to the TV through the existing cable guide. 3. Place lift in location. It must be place on a hard level surface (see Caution section). The unit must be 3/4” - 1” from the end of the bed frame. (optional) Secure unit to the floor using the 4 pre drilled holes, one on each side of mounting bracket. 4. Plug the unit to a 110V power source. (A surge protector is highly recommended) Installation support: We take great pride in manufacturing the best lift systems in the world. Our design and production techniques enable simple installation. In the event that you require assistance, do not hesitate to contact one of our technicians. We will be happy to answer your questions and resolve any problems you encounter during the installation process. Phone Support: 661-257-9282, exrt: tech@auton.com WWW.AUTON.COM 29102 Hancock Pkwy | Valencia, California 91355 Phone: 661-257-9282 | Fax: 661-295-5638 E-mail: tvlifts@auton.com Switch lead and programming switch may be plugged in either port.
Page 1: The Authority in Custom Motorized L
Page 5: Control Box The IR control box come

installation manual - Auton Motorized Systems

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?