Suppression Disconnect Switch 06-472 - Orr Protection Systems

SWITCH TERMINAL BLOCKS
(BACKSIDE OF FACEPLATE)
SUPERVISORY CIRCUIT
FROM CONTROL PANEL
OR ADDRESSABLE
MONITOR MODULE
RELEASE CIRCUIT FROM
CONTROL PANEL OR
-
RELEASING MODULE
+
24 VDC
(SEE NOTE 3)
-
+
DISARMED
R
G
ARMED
SWITCH TERMINAL BLOCKS
(BACKSIDE OF FACEPLATE)
SUPERVISORY CIRCUIT
FROM CONTROL PANEL
OR ADDRESSABLE
MONITOR MODULE
RELEASE CIRCUIT FROM
CONTROL PANEL OR
-
RELEASING MODULE
+
NO NC
NOTES:
1. WIRING DIAGRAM SHOWS SWITCH IN ARMED POSITION.
2. ALL WIRING SHOWN IS SUPERVISED AND POWER LIMITED.
NC NO NC
NO NC
NOTES:
1. WIRING DIAGRAM SHOWS SWITCH IN ARMED POSITION.
2. ALL WIRING SHOWN IS SUPERVISED AND POWER LIMITED.
3. 24 VDC POWER TO SWITCH LEDs SHALL COME FROM THE
ASSOCIATED CONTROL PANEL OR FROM A BATTERY
BACKED 24 VDC, REGULATED, POWER-LIMITED POWER
SUPPLY LISTED FOR FIRE PROTECTIVE SIGNALING USE.
Exhibit 5: Wiring Diagram of Switch with LEDs
Fike ® , 704 SW 10 th Street, P.O. Box 610, Blue Springs, Missouri 64013-0610 U.S.A. ● Tel: (816) 229-3405 ● Fax: (816) 229-4615
P/N 06-472 Rev. 1 page 4 of 4 www.fike.com
NC
TO NEXT DISCONNECT
SWITCH OR END-OF-LINE
RESISTOR
Exhibit 4: Wiring Diagram of Switch without LEDs
-
+
TO ARM, IRM OR
RELEASING SOLENOID
-
+
TO NEXT DISCONNECT
SWITCH OR END-OF-LINE
RESISTOR
TO ARM, IRM OR
RELEASING SOLENOID