Vertical Blinds Installation Instructions - Blinds By Vertican

Track - Mount the installation clips (tab to rear) to the
inside of the casing, or ceiling, a minimum of 1 1/4"
from the window or wall to allow the vanes to tilt open
properly. The end clips should be attached no more
than 4" in from each end of the track. Any centre
supports required should be spaced evenly between
the ends.
Valance - The valance is attached directly to the
mounting surface (casing or ceiling), “sandwiched”
between the surface and the mounting clips as
illustrated. If the front surface of the valance is to be
flush with side casings or wall, you will need a
minimum of 4 ½" window recess.
Valance Detail
Fabric Weights or Bottom Chain
Installation of Fabric Weights with Clip and Chain - Insert a weight into the hem of
each vane. Start at front or back at one of the end vanes, and snap a clip into the hole
on the edge of the weight. Snap the next clip to the same edge of the bottom
weight in the next vane, and carry on to the other end of the track. Do the same
thing with the other side of the vanes. If track is a centre split, cut front and back
chains between centre vanes to allow split.
PVC Chain - Thread supplies chain through keyhole at bottom of each vane leaving
enough chain between to allow vanes to hang straight.
Self-Aligning Vane Hangers
Your track is equipped with a self-aligning mechanism. In the event that a vane becomes misaligned, use
the following procedure to realign all vanes.
1. Rotate the vanes and apply slight pressure at the closed position (you should hear a ratchet sound).
2. Rotate the vanes in the opposite direction, also applying slight pressure at the closed position.