Tiger River® Spas - Olympic Hot Tub Company

Recommendations

Info

115 VOLT GFCI The Ground Fault Circuit Interrupter is a safety device that is designed to detect as little as 5 milliamps (±1mA) of electrical current leakage to ground. Watkins Manufacturing Corporation recommends that the GFCI be tested prior to each use to ensure that it is functioning correctly. With the spa connected to the power supply, push the TEST button. The spa should stop operating and the GFCI power indicator will go out. Wait 30 seconds and then reset the GFCI by pushing the RESET button. The GFCI power indicator will turn on, restoring power to the spa. If the interrupter does not perform in this manner, it is an indication of an electrical malfunction and the possibility of an electric shock. Disconnect the plug from the receptacle until the fault has been identified and corrected. NOTE: Failure to wait 30 seconds before resetting the GFCI may cause the spa’s Power indicator (on the control panel) to blink. If this occurs, repeat the GFCI test procedure. CAUTION: Never use the GFCI as a means to disconnect power to the spa (always unplug it). If the GFCI is tripped while the spa is plugged in, and a power outage occurs, when power returns the GFCI will automatically reset and power will flow to the spa. WATER FEATURE (Available on the CaspianTM model only) The Caspian comes equipped with the AmurTM water feature. This water feature can be turned on or off when the two-speed pump is on low speed (tranquil mode) or high speed. To function correctly, the water feature on/off lever must be placed in the full on position only. If the lever is not in the full on position when the pump is on high speed, it is likely that the water feature will project water substantially farther out into the spa as the on/off lever is opened. This is not proper operation. If this occurs, the pump should be turned off, the water feature lever rotated to the full on position and the pump turned on again. CAUTION: Partial blockage of water flow at entrance of water feature will cause the water to flow farther into or over the spa. Operating Instructions Page 21
Jet Menu CASPIAN (MODEL CHP) Page 22 Jet System 1 (Jet pump 2) • 2 dual port rotary hydromassage jets on right back wall • 6 Precision ® jets in FootWell ® system • 13 Precision jets on back left • 1 Water Feature (right wall) lever must be in ON position Jet System 2 (Jet pump 1) • 1 directional hydromassage jet on back wall • 1 directional hydromassage jet on right back wall • 2 directional hydromassage jets on right wall • 4 Precision jets on front wall • 1 directional hydromassage jet on front wall • 6 Precision jets on left wall
Page 1 and 2: Tiger River® Spas O W N E R ’ S
Page 3 and 4: SAFETY INFORMATION Important Safety
Page 5 and 6: • Your spa uses ground fault circ
Page 7 and 8: SPA SPECIFICATIONS Caspian (Model C
Page 9 and 10: compromised immune system or respir
Page 11 and 12: BENGAL ® (MODEL M / MM) LEVELING P
Page 13 and 14: CONTROLS AND EQUIPMENT CASPIAN MOD
Page 15 and 16: SUMATRAN ® MODEL N OVERHEAD VIEWS
Page 17 and 18: Once your spa has been filled with
Page 19 and 20: 1. Disconnect the power cord from t
Page 21 and 22: it from rain and other moisture. On
Page 23: Chlorine (FAC) residual. If the res
Page 27 and 28: Jet System 1 SmartJet ® lever in t
Page 29 and 30: CONTROL PANEL MENU DISPLAY The cont
Page 31 and 32: 2. On the control panel press the M
Page 33 and 34: CARE OF THE EXTERIOR SPA SHELL Your
Page 35 and 36: VACATION CARE INSTRUCTIONS If you p
Page 37 and 38: Poison Control Center. If a doctor
Page 39 and 40: NOTE: After adding sodium hydrogen
Page 41 and 42: Answer: The cartridge must be repla
Page 43 and 44: WARNING Nitric acid accumulates in
Page 45 and 46: pH: The measure of the spa water’
Page 47 and 48: DISCLAIMERS Watkins Manufacturing C
Page 49 and 50: Date Service Information SPA CARE A
Page 52: This manual contains installation,

Tiger River® Spas - Olympic Hot Tub Company

Create successful ePaper yourself

Delete template?

Save as template?