REVEL ULTIMA GEM loudspeakers
REVEL ULTIMA GEM loudspeakers
REVEL ULTIMA GEM loudspeakers
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CONNECTIONS<br />
BI-AMPLIFIED SYSTEM CONNECTIONS (CONT’D)<br />
HORIZONTAL BI-AMPLIFIED SYSTEM<br />
Using two amplifier channels, remove the shorting straps from the<br />
rear panel; then connect the <strong>loudspeakers</strong> as shown in Figure 14.<br />
Failure to remove the shorting straps when bi-amplifying may<br />
damage some amplifiers.<br />
<strong>GEM</strong> Rear<br />
Shorting Straps<br />
Removed<br />
NOTE: If the “gain factor” of the two amplifier channels is not identical,<br />
a means of adjusting the input level of at least one of the channels<br />
is required. Consult your Revel dealer for specific recommendations.<br />
16<br />
High Frequency Level<br />
(dB)<br />
-1<br />
0<br />
Front<br />
High Frequency<br />
Input<br />
+.5<br />
-.5<br />
-2<br />
+1<br />
0<br />
Rear<br />
+4 0ff<br />
Install Straps for<br />
Single-wired<br />
Operation.<br />
Note:<br />
Remove<br />
Straps for<br />
Bi-wired or<br />
Bi-amplified<br />
Operation.<br />
Install Straps for<br />
Single-wired<br />
Operation.<br />
Low Frequency<br />
Input<br />
Serial No.<br />
Northridge<br />
California<br />
Made in U.S.A.<br />
white<br />
white<br />
Connector<br />
Panel<br />
-2<br />
-1<br />
High Frequency Level<br />
(dB)<br />
0<br />
Front<br />
+.5<br />
-.5<br />
High Frequency<br />
Input<br />
<strong>REVEL</strong> <strong>ULTIMA</strong> <strong>GEM</strong><br />
Owner’s Manual<br />
+1<br />
0<br />
Rear<br />
+4 0ff<br />
Low Frequency<br />
Input<br />
Serial No.<br />
Northridge<br />
California<br />
Made in U.S.A.<br />
red<br />
red<br />
OUTPUT<br />
Pre-Amplifier<br />
(rear) OUTPUT<br />
(one channel shown)<br />
(Optional “Y” Adaptor)<br />
Amplifier<br />
(rear) INPUT<br />
(one channel shown –<br />
use for high frequencies)<br />
Amplifier<br />
(rear) INPUT<br />
(one channel shown –<br />
use for low frequencies)<br />
WARNING<br />
Figure 14. How to connect<br />
the <strong>REVEL</strong> <strong>ULTIMA</strong> <strong>GEM</strong><br />
loudspeaker in a horizontal<br />
bi-amplified system.
Change language