COMPOSITE pt3 - Aux Heater V220.pdf - BenzWorld.org
COMPOSITE pt3 - Aux Heater V220.pdf - BenzWorld.org
COMPOSITE pt3 - Aux Heater V220.pdf - BenzWorld.org
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AR83.70-S-5980A Removing and installing the heater temperature controlled cut-out 28.3.96<br />
MODEL 638.0 /1 /2 up to 15.11.97 with CODE (H12) Warm water auxiliary heater<br />
D5W or B5W<br />
1 Coolant hoses<br />
2 Connector box<br />
3 lClamp<br />
B95 Temperature controlled cut-out<br />
B95.1 Two-pin plug-in connection<br />
e d<br />
Removal, installation<br />
1 Disconnect the ground cable from the battery i AR54.10-S-0005A<br />
Installation: Code the radio<br />
Set the clock<br />
a Danger!<br />
a Danger!<br />
Refer to @<br />
Owner's Manual l<br />
S83.70-2005-06<br />
Risk of explosion due to fuel vapors Do not put stationary heater or engine with AS83.70-Z-0002-01A<br />
igniting, risk of poisoning due to heater booster into operation in confined<br />
combustion gases and risk of injury from spaces or while refuelling. Allow heater unit<br />
burns during and after heater operation. to cool down after operation and wear safety<br />
gloves.<br />
Danger of severe burns to skin and eyes Open cooling system only when coolant AS20.00-Z-0001-01A<br />
from hot coolant spewing out. Coolant is temperature is below 90 °C. Open cover<br />
toxic when swallowed slowly and reduce pressure. Do not fill<br />
beverage containers with coolant. Wear<br />
protective gloves, protective clothing and<br />
protective goggles.<br />
2 Eliminate the pressure from the coolant<br />
circuit<br />
3 Lower the heater with support AR83.70-S-5330-01A<br />
n<br />
*BA83.70-N-1005-01A<br />
4 Disconnect the coolant hoses (1) with clamp l *000589543700<br />
(3)<br />
5 Remove the connector box lid (2) i AR83.70-S-5940-01A<br />
Installation: Make sure the joints are<br />
correctly seated<br />
6 Disconnect the plug-in connection (B95.1)<br />
7 Unscrew the temperature controlled cut-out i Collect any coolant<br />
(B95) in a suitable container<br />
8 Reinstall in opposite order<br />
i Installation: grease the joint of the<br />
temperature controlled cut-out<br />
n<br />
*BR00.45-Z-1015-06A<br />
*BA83.70-N-1002-01A<br />
a Danger!<br />
Accident hazard resulting from vehicle Secure vehicle against starting to move<br />
starting to move by itself with engine running. unintentionally.<br />
Danger of injury resulting from pinching and Wear closed and tight fitting work clothing.<br />
AS00.00-Z-0005-01A<br />
burning when reaching in during the starting<br />
operation or with the engine running.<br />
Do not touch hot or rotating parts.<br />
Copyright Daimler AG 11/25/11 G/06/08. This WIS printout will not be recorded by the update service. Page 1