ION POWER PACK

10. Protection : - Power pack should be equipped
with protection circuit to protect from :-
• Over Charge
• Over Discharge
• Over Temperature
• Over Current
• Short Circuit
• Reverse Polarity
11.
Accessories a) Intelligent Charger with
AC Adaptor & appropriate
cable to charge the power
pack within 4 to 6 hours. (As
per requirement)
b) Intelligent Charger should
have following features:-
c) Protection for reversed
polarity (input or output), low
input voltage, battery
temperature, charging capacity
and time overrun.
d) Internal temperature sensor
and temperature controlled
automatic cooling Fan controls
the internal temperature and
provides intelligent protection.
e) LCD/ LED screen to provide
rich information including
active mode, current, voltage,
total charge (mAh), charging
time and temperature etc.
f) For Lithium-ion batteries:
balance charging, normal
charging, fast charging,
storage, discharging, extdischarging,
charge/ discharge
cycling and battery monitoring.
g) For NiCd/NiMH batteries:
charging-auto, chargingmanual,
discharging, charge/
discharge cycling and forming
charge.
h) Trail- Tech female lockable
co-axis connector with two feet
long coil cord.
i) Trail – Tech male lockable
co-axis connector with two feet
long coil cord.
Board will check practically by
overcharging, over discharging,
over temperature, Over current
short circuiting and connecting in
reverse polarity to power pack and
there should be no harm to power
pack in this condition.
a) Board will check charger, adaptor
and its cable physically. Power pack
to be connected to charger and it
should be fully charged with in time
as shown.
b) Board will check practically
c) Board will check practically by
connecting battery to Intelligent
charger in reverse, low input voltage
and there should be no harm to
charger/battery.
d) Vendors / supplier will produce
certificate to B.O.O in this regard.
e) Board will check it practically that
charger having LCD/LED display
and displays active mode, current,
voltage/total charge(mAh), charging
time and temperature etc.
f) Board will check practically that
charger having balance charging,
normal charging, fast charging,
storage, discharging, charge/
discharge cycle and battery
monitoring provisions/ indications for
lithium batteries.
g) Board will check practically that
charger having provision of charging
–auto, charging manual, discharging,
charge/discharge cycling and
formatting charge for NiCad/Ni Mh
batteries.
h) Board will check it physically and
practically.
i) Board will check it physically and
practically.