Arduino - antrax.de
Arduino - antrax.de
Arduino - antrax.de
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>antrax</strong> Datentechnik GmbH<br />
info@<strong>antrax</strong>.<strong>de</strong> - www.<strong>antrax</strong>.<strong>de</strong><br />
GSM/GPRS/GPS-Shield for <strong>Arduino</strong><br />
Rework instructions for the <strong>Arduino</strong> Board Mega2560 (Atmega2560)<br />
Rework Instructions<br />
29.11.2010<br />
- 1 -<br />
Hasenbrink 4, 32052 Herford, Germany Tel. +49 (0) 5221 929660 Fax +49 (0) 5221 9296628
<strong>antrax</strong> Datentechnik GmbH<br />
info@<strong>antrax</strong>.<strong>de</strong> - www.<strong>antrax</strong>.<strong>de</strong><br />
General<br />
All connectors of the <strong>Arduino</strong> Mega2560, besi<strong>de</strong>s the signals of the SPI interface, are pin compatible to<br />
the <strong>Arduino</strong> Duemilanove and <strong>Arduino</strong> UNO. For fitting of the SPI interface to the GSM/GPRS/GPS-<br />
Shield the following modifications to the connectors shall be ma<strong>de</strong>:<br />
Material for the rework<br />
● Short 4-wire cable (for example ribbon cable)<br />
● long pin sockets (2 sockets with 6 pins each and 2 socket jacks with each 8 pins)<br />
● a socket strip with 4 sockets in row [1]<br />
● a pin hea<strong>de</strong>r with 4 pins in square [2]<br />
How to<br />
The long pin connectors are plugged between the <strong>Arduino</strong> Board and the GSM/GPRS/GPS-Shield.<br />
Before doing so however, the 4 pins of the pin connector, that connect the digital pins 10-13, shall be<br />
turned by 90° outwards. Then sol<strong>de</strong>r the 4-wire ribbon cable to the 4-socket connector [1]. The other<br />
end of the cable is to be sol<strong>de</strong>red to the hea<strong>de</strong>r [2]. Please refer to the correct pin assignment. The single<br />
signals and wires must be connected as follows:<br />
Pin at GSM/GPRS/GPS-Shield Pin at <strong>Arduino</strong>-Board Mega2560<br />
10 – SS 53 – SS<br />
11 – MOSI 51 – MOSI<br />
12 – MISO 50 – MISO<br />
13 – SCK 52 – SCK<br />
- 2 -<br />
Hasenbrink 4, 32052 Herford, Germany Tel. +49 (0) 5221 929660 Fax +49 (0) 5221 9296628
<strong>antrax</strong> Datentechnik GmbH<br />
info@<strong>antrax</strong>.<strong>de</strong> - www.<strong>antrax</strong>.<strong>de</strong><br />
Schematic<br />
- 3 -<br />
Hasenbrink 4, 32052 Herford, Germany Tel. +49 (0) 5221 929660 Fax +49 (0) 5221 9296628