Electric fastening tools - psm-muenchen.de

Special control modules with various options for electric fastening tools
Controllers
EL-Box 2120 for series DLV75/85, also antistatic
EL-Box 3120 H5 for series DLV73 / 5-pole
EL-Box 3120 H6 for series DLV73 / 6-pole – antistatic
• controller for series DLV75/85/73
• adjustable speed
• slow soft start for easy fastener
• engagement
• SPS output for release, "IO" (in order)
• "NIO" (not in order) control signals
• EL-C-Box special desing available (option)
• optional foot switch for counterclockwise
• rotation
Device type for
Order no. series socket
EL-Box 2120 DLV75/85 6-pole
EL-Box 3120 H5 DLV73 5-pole
EL-Box 3120 H6 DLV73 6-pole
Controllers EL-C-Box
with control unit *)
• soft start function
• (via switch “Search Run"
• at the front panel)
• speed adjustment
• (up to 50% of nominal speed via
• pot at the back of the device)
• control device to check the
• fastening operation
• counter for 1 to 99 fastening operation
• the device ensures that all fasteners
• are tightened with the required
fastening torque.In a time slot that
• is adjustable from 0.2 to 10
• seconds the application can be set
• (fastening length, fastening speed, etc.)
• All those cycles during which
torque shut-off occurs ouutside
• the set time slot are "NIO" (not in
• order). Thus it is excluded that the
• cycle is repeated with a fastener
• that has already been run down as
• test electronics does not confirm
• the fastening cycle (IO) but
• indicates "NIO".
• Should there be no torque shut-off, e.g.
if the fastener cannot be run down
• properly, there is no "IO" signal.
If torque shut-off occurs after the
• set time has elapsed, "NIO" is
• indicated. The counter counts those
• fastening operations that are "IO",
• in a range of 1 to 99 fastening operations.
*) The control unit with counter
*) and check is also available for
*) pneumatic tools!
10
• Combination with the counter takes you a major step closer to your goal:
• ensuring maximum quality of the final product with a minimum of
• rejects.
• Counting and checking is microprocessor-controlled and provides
• voltage-free contacts for further processing and integration into a higher-
• ranking control system.
• The fastening tool can be started and stopped via an external release
• signal.
Device type With soft.start......Controll Check For Socket
Order no. fastener speed unit series
control control counter
EL-C-Box 2110 X X X X 75/85 6-pole
EL-C-Box 3110 H5 X X X X 73 5-pole
EL-C-Box 3110 H6 X X X X 73 6-pole