Tech Bulletin December 2008 In this bulletin... - Armour Home ...

http://www.armourhe.co.uk/downloads/systemline/technical/Q12225-AN_Sending_Music_From_PC_To_Server.pdf
3 – Q12475/AN: FAQs. The Technical Support team are often asked common questions regarding various facets
of the Systemline product. We have compiled an FAQ section on the website which you can refer to to see if your
question can be easily answered - plus, as it's online you can quickly access this at anytime.
http://www.armourhe.co.uk/faqs
These are also downloadable from the Armour Home website at the above URLs along with more application notes
relating to networking benefits of the server.
Systemline Modular – New components
Systemline ALM3 Speakers
The new Systemline ALM3 speaker has
recently been introduced to replace the ALM2.
The new speaker model has the following
improvements:
• Part L compliance
• Acoustic improvement with new drive unit
designs and circuitry
• Switchable IR on/off to avoid the purchase of
two model numbers
• Direct upgrades via QRC file including
bass/treble adjustment
Installation methods remain the same, as do the
punch down terminations.
To enable simple and efficient configuration of the SLM speaker we recommend all
installers carry an LRN7 remote that's loaded with an installer .qrc file. This file can
be deleted from the remote using the ARC7 editor. The SLM speakers can still be
configured using the conventional method which involves removing R36 in
expansion speakers and the use of address 2 in sub-zones. These procedures
can be used in single source installs where the LRN7 is not part of the Single
Source Starter Pack.
PIM-4
The new external power input module allows up
to four pairs of speakers to be powered by one
PSM130, reducing the need for additional
power supplies. The power input connection is
direct from the transformer, with RJ45 connect
to the speakers.
Specifications:
• 1 x Power input (RJ45 socket)
• 4 x Power output (RJ45 socket)
• Dimensions (WxDxH): 102 x 48 x 81.5mm
• Requires PSM130 power supply active to
drive
Product Code: M-PIM4
CIM/2
This unit is an external version of the CIM wallplate allows the external connection
of a stereo source device to a redundant RJ45 socket that may currently be
positioned for networking or telephony use. Connection of the source and IR
control window emitter is as the current CIM with an RJ45 socket on the reverse.
Importantly the new CIM/2 also has a volume limitation (>-6db) toggle. This allows
the attenuation an overly loud source device to match the other source devices in
the system. Good problem solver!
about:blank
of 5 24/03/2009 10:02