97032 Manual - Henkel

More documents

Recommendations

Info

1 Lampmodule 3 CHANGING THE LAMP-MODULE 2 2 Remove: 1....2....3 Insert: 3....2....1 REMOVING TRANSPORT SAFETY CUSHIONS 11111 11111 00000 00000 11111 00000 00000 11111 11111 11111 00000 00000 11111 00000 00000 11111 11111 11111 00000 00000 11111 00000 00000 11111 0000011111 00000 11111 3
1. Prior to operation of the unit check the following items carefully: Transport Safety Cushions During transport lamp is protected by foam cushions. As failure to remove these will destroy the lamp, it is also electrically disconnected during transport. Follow the instructions “Changing the Lamp-Module” to remove the foam cushions. Mains Supply Make sure voltage and frequency on the nameplate match with your local mains supply. Connect power cord to a properly grounded AC outlet. UV-Lightguide Insert the flexible LIQUID LIGHTGUIDE with the Ø16mm fitting into the lightguide socket in the front panel of the lightsource. Attention: Shutter will not operate unless lightguide is fully inserted. Treat the lightguide with care, it is an optical instrument. Do not kink or crush it and do not bend it too sharply to avoid light losses. From time to time clean lightguide end faces with a soft tissue and solvent. When using a dual branch LIQUID LIGHTGUIDE the two branches must be positioned vertically above each other in the lightguide socket in the front panel. Only this position ensures maximum radiation output. Insert the lightguide all the way into the socket and rotate it until it snaps into vertical position. For technical reasons the radiated power of the two branches may differ up to a ratio of 40:60 percent. Ventilation Cooling air is sucked through opening at the bottom of the unit, hot air is expelled at the back. Both openings may not be obstructed in order to allow free ventilation. Obstruction of these openings will cause unit to overheat. Vapours of Solvents Vapours of fluorinated or chlorinated hydrocarbon solvents will corrode the lamp and the quartz lenses – even in small concentrations. Avoid these solvents in the vicinity of the unit. If you cannot avoid them, place the unit as high as possible, as vapours are heavier than air. Explosive Surroundings This unit is not meant for operation in explosive surroundings. Protection against UV-Radiation To avoid tissue damage do not expose the unprotected eye or skin to the ultraviolet light. For more information on UV radiation please refer to chapter 6. 4
Page 1 and 2: 97032 Manual
Page 3: 000000 h FRONT PANEL REAR PANEL 0 0
Page 7 and 8: 4. Changing the Lamp-Module The cha
Page 9: 7. Technical Data Model: Loctite 97

97032 Manual - Henkel

Create successful ePaper yourself

Delete template?

Save as template?