fc-1 fill-up & circulating tool with sliding sleeve - Frank's International

More documents

Recommendations

Info

FACTS TM FILL ILL-UP SYSTEM YSTEM & CEMENTING EMENTING TOOL OOL UP & C The FACTS TM . . . Frank’s has made cementing operations safer. Frank’s innovative FC-1 Fill-Up Tool and unique cementing adapter with remote ball dropping mechanism has been combined with a patented plug system to provide the drilling industry with a safer work environment and less rig up. The FACTS TM eliminates large cumbersome cementing heads because cementing operations can be conducted directly through the FC-1 Fill-Up Tool. FASTER . . . Installation of FACTS TM prior to casing run allows cementing operations to begin without delay. SAFER . . . Installation is completed on the floor. Actuation of plug dropping mechanism occurs remotely. FASTER + SAFER = DECREASED DRILLING COST For more information call 1-800-833-7265 or e-mail info@frankscasing.com www.frankscasing.com Copyright ª 2003 Frank’s Casing Crew & Rental Tools, Inc., Lafayette, LA
FACTS TM Fill-up & Cementing Tool System Technical Data Sheet Pressure Rating Pressure applied to the tool from inside the casing results in a piston force acting upward on the tool subjecting it to buckling forces. For this reason, pressure applied to the tool should not exceed the pressures listed below. FACTS TM FC Tool Pressure Rating (psi) (For Top Drive w/5ft from link ears to 4-1/2 IF Pin Shoulder) Bail Length (ft) Size up to 16 up to 22 7" to 8-5/8" 5000 5000 9-5/8" & 9-7/8" 5000 5000 10-3/4" 5000 5000 11-3/4" 5000 4400 13-3/8" & 13-5/8" 5000 2500 16" 3000 1700 18-5/8" 2500 1300 20" 2500 1100 Circulation Rates Circulation Mode - During Circulation, any flow rate needed can be achieved, especially if circulating through tight zones. Typically, flow rates up to 25 bpm can be achieved for short periods of time. High rates and duration may erode mud saver valve. If circulating greater than 6 hours at 15bpm, it is recomended that the mud saver valve be removed. Cementing Mode - During cementing, flow rates of 10 bpm for up to 3 hours can be achieved. Displacement rates and times in excesss of 10 bpm for 3 hors can result in a lower observed plug landing pressure. For more information call 1-800-833-7265 or e-mail info@frankscasing.com www.frankscasing.com Copyright ª 2003 Frank’s Casing Crew & Rental Tools, Inc., Lafayette, LA REVISED 6/7/04
Page 1 and 2: FC-1 AND FC-2 FILL ILL-UP UP AND CI
Page 3 and 4: FC-1 Rigged Up FC-1 Rigged Up This
Page 5: Figure 1 Frank’s Fill-up tool dre

fc-1 fill-up & circulating tool with sliding sleeve - Frank's International

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?