NGV A3 VALVE MANUAL - G.m.v.
NGV A3 VALVE MANUAL - G.m.v.
NGV A3 VALVE MANUAL - G.m.v.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ENG<br />
1.06<br />
1 0991 483 EN - 06.09.2012<br />
4 / 50<br />
<strong>NGV</strong> <strong>A3</strong> <strong>VALVE</strong> <strong>MANUAL</strong><br />
INSTALLATION, USE AND MAINTENANCE<br />
4.5 TEST OF THE MONITORING SYSTEM 32<br />
4.6 FAULT SIMULATION ON OUTPUT RDY AND RUN 32<br />
4.6.1 TEST RUN ALWAYS ON 32<br />
4.6.2 TEST RDY ALWAYS OFF 32<br />
4.6.3 TEST RUN ALWAYS OFF 32<br />
4.6.4 TEST RDY ALWAYS ON 32<br />
4.6.5 EXIT RUN-RDY TEST 32<br />
5 PROGRAMMING 33<br />
5.1 SYSTEM PARAMETERS 33<br />
5.2 COMPLETE MENÙ 34<br />
5.3 MENÙ 35<br />
- 1 - DIAGNOSTICS 35<br />
- 2 - ALLARM 35<br />
- 3 - ALARM AND FAULT RESET 35<br />
- 4 - ADJUSTMENTS 36<br />
- 5 - SETTINGS 37<br />
- 6 - UPWARD PARAMETERS 38<br />
- 7 - DOWNWARD PARAMETERS 38<br />
- 8 - OUTPUT FUNCTIONS 39<br />
- 9 - TEST 39<br />
- 10 - ADVANCED PROGRAMMING 40<br />
5.4 CHART OF OUTPUT PROGRAMMABLE FUNCTIONS 40<br />
5.5 CHART OF FAILURES 41<br />
5.6 ACCESSORIES 41<br />
6 MAINTENANCE AND FAULT ANALYSIS 42<br />
6.1 PROGRAMMED MAINTENANCE 42<br />
6.2 PERIODICAL MAINTENANCE AND CHECKS TABLE 42<br />
6.3 MAINTENANCE SCHEDULES 42<br />
6.4 FAULT ANALYSIS 44<br />
6.4.1 TROUBLESHOOTING 45<br />
6.5 ADJUSTING THE SENSORS 47<br />
6.5.1 SENSOR S1 47<br />
6.5.2 SENSOR S2 47<br />
6.5.3 SENSOR S3 47<br />
7 CERTIFICATES 48<br />
7.1 TYPE EXAMINATION 48<br />
7.2 CONFORMITY 48<br />
ENG<br />
All rights reserved.<br />
Any kind of exploitation in any form and by any means is forbidden without a written permission of GMV Spa.<br />
GMV Spa, within technical or manufacturing progress, reserves the right to modify parts or this manual without notice.<br />
Drawings, descriptions and data included in this manual are indicatives.<br />
For all the data not included in this manual refer to the documents of any single part.<br />
To guarantee the products security, do not use spare parts not genuine or not approved by GMV Spa.<br />
GMV Spa will not assume any responsibility if the instructions included in this manual are not observed.<br />
/c2 DT 06/09/2012 2C CR 06/09/2012 2c6<br />
GF 06/09/2012<br />
Information and support:<br />
FLUID DYNAMICS EQUIPMENTS<br />
AND COMPONENTS FOR LIFTS<br />
UNI EN ISO 9001<br />
Certified Company<br />
GMV SPA<br />
Via Don Gnocchi, 10 - 20016 PERO – Milano (Italy)<br />
TEL. +39 02 33930.1 - FAX +39 02 3390379<br />
http://www.gmv.it - e-mail: info@gmv.it<br />
Please visit www.gmv.it to check for<br />
updates of this document or further information about GMV products