FLOORING TECHNOLOGIES - Bostik

NivoTech PSG - H
Polysulfide Grout for Horizontal Applications
Product description:
It is a flowable polysulfide-based, two-component insulation material
that is resistant to jet fuels and chemicals, and suitable for use in wide
and narrow grouting.
Application areas:
• Gas stations, cars
• Carwash areas and airports
• Chemical discharge areas and all kinds of areas which may expose
to chemicals
Features:
• A two-component, solvent-free insulation material.
• Flowable
• Resistant to chemicals (jet fuels, technical oils, fuel oil, biodiesel
fuels, diluted inorganic acid and solutions) salt.
• Resistant to aging, weather conditions and UV lights.
• Not affected from weather conditions 24 hours after application
(at 20°C)
Technical data:
Colour
A component
B component
Cream
Black
Shore A Hardness > 25
Density gr/cm 3
A component
B component
Tensile strength (N/mm 2 ) > 8
Using time (23ºC 50 Rh)
Surface drying (23ºC 50 Rh)
Curing time (23ºC 50 Rh)
1,58 ± 0,02
1,58 ± 0,02
60 - 100 min
≤ 3 hours
≤ 8 hours
Coverage:
Usage amounts may vary according to the sizes of the joint gap.
Width of Joint Gap
mm
5
10
20
Package:
5 kg tins
500 gr tins
Depth of Joint Gap
mm
5
10
12
Coverage
gr/m
40
160
375
Storage:
• They should be protected from water, frost and adverse air
conditions.
• They should be kept dry and cool on wooden pallets at between
+10°C and +25°C in moisture free conditions.
• The opened products should be consumed immediately.
• Maximum 3 tins should be stocked on each other.
• Shelf life is maximum 6 months conditional to complying with the
abovementioned storage conditions.
Technical data are approximately provided according to a temperature
of + 20°C and a relative humidity of 50%.
Preparing of the substrate:
• The substrates to be applied on should be clean, dry and oil- and
dust-free.
• Bostik NivoTech PSG – H is constituted from two components.
100 gr of A component and 10 gr of B component by weight are
mixed until it becomes a homogenous mixture.
Application:
• The mixture that is prepared with simple applications in small areas
can be applied with a muzzleloader pump-gun and a spatula.
• In large scale applications, usually dosage-adjusted machines are
used.
Flooring Technologies
16
After application:
Contaminated areas and used tools should be cleaned with white
spirit or alcohol within 10 minutes.
BOSTİK is only responsible for the product quality and cannot be held responsible for its mis-use except for the recommendations regarding where and/or how the product shall be used. This technical bulletin hereby is valid until it is renewed. BOSTIK’s right to amend the products
in accordance with technical developments is reserved.