Marking Technology - Grün GmbH

Marking Technology
1. Hand-guided devices for paint, cold spray plastic, cold
plastic, thermoplastic and for the application of
marking tape
1.1 Air-atomization technology (AIRSPRAY) for paint
Model range City
Paint spraying devices of the model range City work according to the airatomization
principle AIRSPRAY. They are suitable for application of
high-solid marking paints on solvent or water base.
Options as for example drive unit, hand spray gun and bead dispenser
are available.
Devices of the model range City are used with preference on
car-parks, multi-storey car parks, at keep-out areas and for repair
markings.
City - 5
City - 100
_______________________________________________________________________________________
1.2 AIRLESS – Technology (high-pressure spraying) for paint and
cold spray plastic
Model range LineLazer
(with LineDriver)
Paint spray devices of the model range LineLazer work with AIRLESS–
technology (high-pressure-atomization-technique without air).
In this case the paint is compressed in special pumps and sprayed by means
of special AIRLESS – nozzles. The results are
little overspray
sharp-edged lines
even paint distribution even at wide lines
AIRLESS – technique is suitable especially for HS-paints on water base,
because no hot compressor air for atomization is used. The spraying width can
be adjusted very easily. Line widths up to 50 cm are possible with the wide line
spraying unit (option)
LineLazer IV 3900 G
with 2 spray guns
Page 4