OM, Rider 11, Rider 13, Rider 11 Bio, Rider 13 Bio ... - Husqvarna

More documents

Recommendations

Info

MAINTENANCE RIDER 11 BIO/13 BIO Service position for BioClip 90 The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position. Placing in service position 1. Position the machine on flat ground. Apply the parking brake (1). Adjust the cutting unit to the lowest cutting height and lower the cutting unit. P 1 6017-218 2. Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood). 6017-219 3. Remove the two support wheels from under the front hood. 6017-220 English – 33
MAINTENANCE RIDER 11 BIO/13 BIO 4. Fit the support wheels on either side of the rear of the cutting unit. WARNING! Wear protective glasses when dismantling the cutting unit. The spring which tensions up the belt can go off and cause personal injury. 5. Disengage the spring from the drive belt tensioning wheel. 6017-221 8009-583 6. Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut. 8009-122 7. Engage the strut in the holder. 6017-223 34 – English
Page 1 and 2: Operator´s manual Rider 11 Rider 1
Page 3: Dear customer INTRODUCTION Thank yo
Page 6 and 7: Safety instructions SAFETY INSTRUCT
Page 8 and 9: Driving on slopes Driving on slopes
Page 10 and 11: SAFETY INSTRUCTIONS • If leaks ar
Page 12 and 13: PRESENTATION Presentation Congratul
Page 14 and 15: Throttle and Choke lever PRESENTATI
Page 16 and 17: Lever for adjustment of cutting hei
Page 18 and 19: DRIVING Cold engine: 4. Push the th
Page 20: DRIVING 3. Select the required cutt
Page 23 and 24: Dismantling of the machine hoods En
Page 25 and 26: MAINTENANCE Checking and adjustment
Page 27 and 28: Adjustment of the throttle wire If
Page 29 and 30: MAINTENANCE Checking of the fuel pu
Page 31 and 32: MAINTENANCE Main fuse The fuse is l
Page 33: MAINTENANCE Adjustment of the cutti
Page 37 and 38: Checking the blades To achieve the
Page 39 and 40: Check the transmission’s oil leve
Page 41 and 42: TROUBLE SHOOTING SCHEDULE Problem P
Page 43 and 44: TECHNICAL DATA Dimensions Rider 11
Page 45 and 46: EU-DECLARATION OF CONFORMITY EC dec
Page 47 and 48: ○ ○ ○ ○ ○ ○ ○ ○ ○
Page 49 and 50: ○ ○ ○ ○ ○ ○ ○ ○ ○

OM, Rider 11, Rider 13, Rider 11 Bio, Rider 13 Bio ... - Husqvarna

Create successful ePaper yourself

Delete template?

Save as template?