Manual - Tannoy

More documents

Recommendations

Info

FREQUENCY TERMINAL 'EARTH' OR 'GROUND' TERMINAL LOW FREQUENCY POSITIVE(+) TERMINAL TERMINATION PANEL fig. 3 TO RIGHT SPEAKER + - L + - R POWER AMPLIFIER LINK WIRES REMOVED TO 'GROUND' OR 'EARTH' CONNECTION ON AMPLIFIER (OPTIONAL) BI-WIRE CONNECTION 42
BI-WIRING CONNECTIONS Bi-wiring releases the full potential of the <strong>Tannoy</strong> Kingdom Royal loudspeakers. Two complete sets of cable are required. Switch the amplifier off. Deal with each ‘side’ of the system separately. Label two of the cables Left LF and Left HF (low frequency and high frequency), referring to the diagram (see fig. 3). Do the same for the right pair. Undo the loudspeaker terminals, remove and retain the Bi-wiring links so that the same polarity terminals are no longer joined. It is essential to get the polarity correct. If your amplifier does not have separate output terminals for bass and treble then, at the amplifier end of the cable, connect the Left LF+ and HF+ cables together. Then wire to the amplifier Left channel positive terminal marked + (plus) or coloured red. Note the polarity marking on the cable. At the loudspeaker end connect the cables marked Left LF+ and LF- to the appropriate left speaker LF terminals. Connect the Left HF+ and HF- to the appropriate + and - left speaker HF terminals. Make the same connections with the Right LF and HF cables. Note the polarity of the cable and be sure to connect + to + and - to -, the LF cables to LF terminals and HF to HF. Switch on the amplifier with the volume turned down. Select a favourite source and carefully turn up the volume. Check that bass and treble sounds come from both speakers. If not, switch off and recheck the connections. Connect the Left LF- and HF- cables together to the amplifier negative terminal marked - (minus) or black. 43
Page 1: Manual 1
Page 4: TANNOY - A SHORT HISTORY In the ear
Page 8: INTRODUCTION TO THE KINGDOM ROYAL T
Page 12: Its hard-edge roll surround has a v
Page 16: BASS DRIVER To deliver accurate and
Page 20: At crossover component level, the c
Page 24: UNPACKING CAUTION: Each Kingdom Roy
Page 28: POSITIONING Place the loudspeakers
Page 32: CABLE CHOICE Always use the best qu
Page 35 and 36: AMPLIFIER CONNECTIONS Referring to
Page 37: + - + - fig. 2 TO RIGHT SPEAKER + -
Page 40: BI-WIRING THEORY Loudspeakers need
Page 45: POWER AMPLIFIER LINK WIRES IN PLACE
Page 48 and 49: TERMINATION PANEL LOUDSPEAKER SYSTE
Page 51 and 52: RUNNING IN Like all loudspeakers, t
Page 55 and 56: CARE OF CABINET The cabinet may be
Page 59 and 60: WARRANTY No maintenance of the King
Page 62: A statement in engineering excellen

Manual - Tannoy

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?