DWI ) 10L6 ( GB - Ardo

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance Open the door,press the On/Off button to switch on the appliance .
Fill the detergent dispenser
Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Check the rinse aid level
Electric indicator on control panel (if provided).
Check the regeneration
salt level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Load the baskets
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Select a programme
Press the Programme Button until the selected programme lights up.
( See the section entitled“ Operationg instruction ”)
Running the dishwasher
Turnonthewatertap ,closethedoor.Themachinewillstartworkingafterabout10seconds.
Changing the programme
Add forgotten dishes in the
dishwasher.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Programme Button for more than 3 seconds to cancel the running programme.
3. Select a new programme.
4. Restart the dishwasher.
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again after 10 seconds.
Open the door carefully.
Hot steam may escape
when the door is opened!
If the appliance is switched
off during a wash cycle.
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch off the appliance
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
Turn off the water tap,
unload the baskets
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.