Panasonic' - Tecnicosaurios

SA-AK15
Drive Rack
F¡9. 1
Top view
@
ññii-r''it" notOlng tne Drive Rack and Carrier Lever' inserthe Trav
Jase on the Mechanism Base ¡n the direction of arrow @ until
the Tray Base stops as snown in figure l Release only the
óJrri"il"u"r. and push the Tray Base together with the Drive
ñá.r.. nrtur, "nguging the gear, release the Drive Rack which
held and leed lhe TraY Base slowly'
DriveRack
Tray Base
Tray Base
Tray Base
@
ora-ra* tn" Tray Base in the direction of arrow @ to the end until it stops'
Make sure the mark . ' on the Tray Base is aligned with the mark' on
in" ó*" n""r. as shown in figure 2before closing the Tray Base (ln
case tf'at tf,e statement above L not operated draw the Tray Base agaln
from steP 2)
I Main Component Replacement Procedures
-Septacement of the Traverse De9!
@
Follow the procedures in Disassembly
of the Traverse
unit r GtÍD-GGDr
Traverse Deck
Servo P.C.B.
@
ox3
, .... '.:
l , ¡.{.É"r,
Desolderthe 4legs of the
2 molors and Pull out the
Servo P.C.B.
Servo P.C.B
Remove the flex¡ble
cable CN701.
@
Widen the 2 bosses with a flat
screwdriver and pull out the 2 pins
Then remove the Traverse Deck
. Removal of the flexible cable
Push the top of the connector in
the direction of the arrow @ ,
and then Pull out the flexible
cable in the direction of the
arrow \2, .
tH
Flexible
cable
+ F
d'/
v
Flexible cable
bOSS
pin
Note :
Insert a short Pin into the
flexible cable for traverse
unlt.
-l.Ssrto,l Pin
@
[XrN2+6G] (Brass)