Wireless Smoke Detector Type 3 - IntelliHome

More documents

Recommendations

Info

The smoke detector should be installed in the centre of the room, on the ceiling, or for a sloping roof at the highest point, as smoke rises and gathers in this area. This guarantees the earliest possible alarm warning. <strong>Smoke</strong> alarms should be installed in all rooms, but not directly above the cooking area in the kitchen or the bath, where dust concentrates. Ensure that the smoke detector is not installed directly on or in the vicinity of large metal objects as they can affect the radio range. 5. Installation Please follow these steps to install the Convia smoke detector: • At the place where you are going to install the detector, draw a horizontal line six inches long. • Remove the mounting bracket from your unit by rotating it counterclockwise. • Place the bracket so that the two longest hole slots are aligned on the line. In each of keyhole slots, draw a mark to locate a mounting plug and screw. • Remove the bracket. • Using a 3/16-inch (5mm) drill bit, drills two holes at the marks and insert plastic wall plugs. Put the detector away from getting plaster dust on it when you drill holes for mounting. Page 8 of 12
• Using the two screws and plastic wall plugs (all supplied), attach the bracket to the wall. • Line up the slot of the backet and the detector. Push the detector onto the mounting bracked and turn it clockwise to fix it into place. Pull outward on the detector to make sure it is securely attached to the mounting bracket. • Do not insert the battery at this stage (9V). Please follow the steps of the next chapter before you insert the battery. • How to install the battery: • The smoke detector requires an alkaline battery • Match terminals on the end(s) of the battery with opposite terminal connectors on the detector. Be sure to insert the alkaline battery in the position shown on the detector. • When terminals are properly matched, push battery firmly in until it snaps and cannot be shaken loose. The smoke detector will not work until you insert the battery properly! Page 9 of 12
Page 1 and 2: Wireless Smoke Detector (Type 3) Op
Page 3 and 4: Table of contents: Chapter: Page: 1
Page 5 and 6: 3. Safety- and maintenance- referen
Page 7: Locations for placing smoke detecto
Page 11 and 12: 7. Registering the smoke detector w

Wireless Smoke Detector Type 3 - IntelliHome

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?