rtf model - CML Distribution
rtf model - CML Distribution
rtf model - CML Distribution
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Remove excess length of pushrod with wire<br />
cutters.<br />
Test fit the two horizontal stabiliser panels.<br />
The joiners pass through a tube at the rear of the<br />
fuselage.<br />
The panels should be angled downwards. (anhedral)<br />
Fit the two fixing screws to lock the joiner in place.<br />
Test fit the two wing panels on to the fuselage<br />
Apply adhesive to the contact faces on the wing and<br />
fuselage and press firmly together use pins or tape<br />
to hold in place.<br />
Wipe off any excess adhesive and allow to dry.<br />
Repeat procedure for the other wing panel.<br />
SECTION 5: FINAL SET UP<br />
Locate the elevator pushrod, control horn, fixings<br />
and backplate.<br />
position the control horn on the moulded recess on<br />
the elevator in line with the servo arm and fix in<br />
place with screws and backplate.<br />
Insert the pushrod through the clamp connectors in<br />
the servo arm and control horn.<br />
WARNING<br />
With the battery connected and the <strong>model</strong><br />
switched on the motor is live. The Electronic<br />
speed controller (ESC) will go through its start<br />
up procedure and will emit a series of beeps<br />
while it configures throttle positions. The<br />
motor could start unexpectedly and we<br />
recommend that the <strong>model</strong> is restrained during<br />
handling.<br />
Ensure that transmitter is switched on with throttle<br />
down and all trims central.<br />
Open the hinged battery bay door by turning the<br />
catches.<br />
Insert into the battery and ensure that battery and<br />
ESC leads project out of the aperture.<br />
Connect the battery and ESC leads together<br />
Red-red and Black-Black and close the battery<br />
cover using the catches to lock it in place.<br />
Align elevators with mould line in fuselage and<br />
gently tighten connectors until the controls are<br />
checked.<br />
Uncoil the receiver aerial and fully extend to hang<br />
off the rear of the aircraft.<br />
10