Table of Dimensions â Gap Seals
Table of Dimensions â Gap Seals
Table of Dimensions â Gap Seals
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
www.bergab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 223-3071<br />
Sealing a high frequency<br />
grinding spindle<br />
The GMN Labyrinth Seal “L” Type has to<br />
protect the high precision bearings against<br />
grinding chips and lightly splashing liquids.<br />
The excess pressure caused by the oil mist<br />
lubrication increases the sealing efficiency.<br />
To protect the seal against splashing liquids<br />
when the spindle is stationary an additional<br />
front plate should be used.<br />
Figure 17<br />
Sealing a drilling sleeve<br />
The grease lubricated bearings have to be<br />
protected against cutting oil and chips.<br />
Due to the vertical mounting position the<br />
flange must be designed correctly because<br />
it is not possible to protect the inside against<br />
vertical splashing liquids by an uncovered<br />
non-contact seal.<br />
Firgure 18<br />
GMN Non Contact <strong>Seals</strong><br />
Typical Applications<br />
Sealing a conveyer roller<br />
The grease lubricated ball bearing <strong>of</strong> the<br />
roller has to be protected against dust and<br />
coarse granular contamination from the<br />
outside.<br />
Mounting<br />
For mounting a bushing is used to push<br />
the seal onto the shaft and into the housing<br />
in one operation. To reach wobblefree<br />
running make sure that the inner ring is<br />
square against the shoulder <strong>of</strong> the shaft.<br />
19<br />
Figure 19<br />
www.bergab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 223-3071