MSDS for #01405 - KRYLON SPRAY PAINT - Dick Blick

MSDS for #01405 - KRYLON SPRAY PAINT
Page 1 of 5
MATERIAL SAFETY DATA SHEET
53569
03 00
DATE OF PREPARATION
Mar 16, 2013
SECTION 1 — PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NUMBER
53569
PRODUCT NAME
KRYLON® ColorMaster with Covermax Technology, Satin Island Splash
MANUFACTURER'S NAME
Krylon Products Group
Cleveland, OH 44115
Telephone Numbers and Websites
Product Information (800) 247-3268
www.krylon.com
Regulatory Information (216) 566-2902
Medical Emergency (216) 566-2917
Transportation Emergency* (800) 424-9300
*for Chemical Emergency ONLY (spill, leak, fire, exposure, or
accident)
SECTION 2 — COMPOSITION/INFORMATION ON INGREDIENTS
% by Weight CAS Number Ingredient Units Vapor Pressure
14 74-98-6 Propane
ACGIH TLV 1000 PPM 760 mm
OSHA PEL 1000 PPM
13 106-97-8 Butane
ACGIH TLV 1000 PPM 760 mm
OSHA PEL 800 PPM
18 108-88-3 Toluene
ACGIH TLV 20 PPM 22 mm
OSHA PEL 100 ppm (Skin)
OSHA PEL 150 ppm (Skin) STEL
0.1 100-41-4 Ethylbenzene
ACGIH TLV 20 PPM 7.1 mm
OSHA PEL 100 PPM
OSHA PEL 125 PPM STEL
35 67-64-1 Acetone
ACGIH TLV 500 PPM 180 mm
ACGIH TLV 750 PPM STEL
OSHA PEL 1000 PPM
1 112926-00-8 Amorphous Precipitated Silica
ACGIH TLV 10 mg/m3 as Dust
OSHA PEL 6 mg/m3 as Dust
2 13463-67-7 Titanium Dioxide
ACGIH TLV 10 mg/m3 as Dust
OSHA PEL 10 mg/m3 Total Dust
OSHA PEL 5 mg/m3 Respirable Fraction
SECTION 3 — HAZARDS IDENTIFICATION
ROUTES OF EXPOSURE
INHALATION of vapor or spray mist.
EYE or SKIN contact with the product, vapor or spray mist.
EFFECTS OF OVEREXPOSURE
EYES: Irritation.
SKIN: Prolonged or repeated exposure may cause irritation.
INHALATION: Irritation of the upper respiratory system.
HMIS Codes
Health 2*
Flammability 3
Reactivity 0
May cause nervous system depression. Extreme overexposure may result in unconsciousness and possibly death.
Item Numbers: 01405-2066 page Page 1 of 5

MSDS for #01405 - KRYLON SPRAY PAINT
Page 2 of 5
53569
Prolonged overexposure to hazardous ingredients in Section 2 may cause adverse chronic effects to the following organs or systems:
the liver
the urinary system
the cardiovascular system
the reproductive system
SIGNS AND SYMPTOMS OF OVEREXPOSURE
Headache, dizziness, nausea, and loss of coordination are indications of excessive exposure to vapors or spray mists.
Redness and itching or burning sensation may indicate eye or excessive skin exposure.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
None generally recognized.
CANCER INFORMATION
For complete discussion of toxicology data refer to Section 11.
SECTION 4 — FIRST AID MEASURES
EYES:
SKIN:
INHALATION:
INGESTION:
Flush eyes with large amounts of water for 15 minutes. Get medical attention.
Wash affected area thoroughly with soap and water.
Remove contaminated clothing and launder before re-use.
If affected, remove from exposure. Restore breathing. Keep warm and quiet.
Do not induce vomiting. Get medical attention immediately.
SECTION 5 — FIRE FIGHTING MEASURES
FLASH POINT
LEL UEL EXTINGUISHING MEDIA
Propellant < 0 °F
1.0
12.8 Carbon Dioxide, Dry Chemical, Foam
UNUSUAL FIRE AND EXPLOSION HAZARDS
Containers may explode when exposed to extreme heat.
Application to hot surfaces requires special precautions.
During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms may not be immediately
apparent. Obtain medical attention.
SPECIAL FIRE FIGHTING PROCEDURES
Full protective equipment including self-contained breathing apparatus should be used.
Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure
build-up and possible autoignition or explosion when exposed to extreme heat.
SECTION 6 — ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Remove all sources of ignition. Ventilate the area.
Remove with inert absorbent.
SECTION 7 — HANDLING AND STORAGE
STORAGE CATEGORY
Not Available
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Keep away from heat, sparks, and open flame. Vapors will accumulate readily and may ignite explosively.
During use and until all vapors are gone: Keep area ventilated - Do not smoke - Extinguish all flames, pilot lights, and heaters - Turn off
stoves, electric tools and appliances, and any other sources of ignition.
Consult NFPA Code. Use approved Bonding and Grounding procedures.
Contents under pressure. Do not puncture, incinerate, or expose to temperature above 120F. Heat from sunlight, radiators, stoves, hot water,
and other heat sources could cause container to burst. Do not take internally. Keep out of the reach of children.
SECTION 8 — EXPOSURE CONTROLS/PERSONAL PROTECTION
PRECAUTIONS TO BE TAKEN IN USE
Use only with adequate ventilation.
Avoid contact with skin and eyes. Avoid breathing vapor and spray mist.
Wash hands after using.
This coating may contain materials classified as nuisance particulates (listed "as Dust" in Section 2) which may be present at hazardous
levels only during sanding or abrading of the dried film. If no specific dusts are listed in Section 2, the applicable limits for nuisance dusts
are ACGIH TLV 10 mg/m3 (total dust), 3 mg/m3 (respirable fraction), OSHA PEL 15 mg/m3 (total dust), 5 mg/m3 (respirable fraction).
VENTILATION
Local exhaust preferable. General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure
limits. Refer to OSHA Standards 1910.94, 1910.107, 1910.108.
RESPIRATORY PROTECTION
If personal exposure cannot be controlled below applicable limits by ventilation, wear a properly fitted organic vapor/particulate respirator
approved by NIOSH/MSHA for protection against materials in Section 2.
Item Numbers: 01405-2066 page Page 2 of 5

MSDS for #01405 - KRYLON SPRAY PAINT
Page 3 of 5
53569
When sanding or abrading the dried film, wear a dust/mist respirator approved by NIOSH/MSHA for dust which may be generated from this
product, underlying paint, or the abrasive.
PROTECTIVE GLOVES
None required for normal application of aerosol products where minimal skin contact is expected. For long or repeated contact, wear
chemical resistant gloves.
EYE PROTECTION
Wear safety spectacles with unperforated sideshields.
OTHER PRECAUTIONS
Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal.
SECTION 9 — PHYSICAL AND CHEMICAL PROPERTIES
PRODUCT WEIGHT 6.27 lb/gal 751 g/l
SPECIFIC GRAVITY 0.75
BOILING POINT

MSDS for #01405 - KRYLON SPRAY PAINT
Page 4 of 5
53569
TOXICOLOGY DATA
CAS No.
Ingredient Name
74-98-6 Propane
LC50 RAT 4HR Not Available
LD50 RAT
Not Available
106-97-8 Butane
LC50 RAT 4HR Not Available
LD50 RAT
Not Available
108-88-3 Toluene
LC50 RAT 4HR 4000 ppm
LD50 RAT
5000 mg/kg
100-41-4 Ethylbenzene
LC50 RAT 4HR Not Available
LD50 RAT
3500 mg/kg
67-64-1 Acetone
LC50 RAT 4HR Not Available
LD50 RAT
5800 mg/kg
112926-00-8 Amorphous Precipitated Silica
LC50 RAT 4HR Not Available
LD50 RAT
4999. mg/kg
13463-67-7 Titanium Dioxide
LC50 RAT 4HR Not Available
LD50 RAT
Not Available
SECTION 12 — ECOLOGICAL INFORMATION
ECOTOXICOLOGICAL INFORMATION
No data available.
SECTION 13 — DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD
Waste from this product may be hazardous as defined under the Resource Conservation and Recovery Act (RCRA) 40 CFR 261.
Waste must be tested for ignitability to determine the applicable EPA hazardous waste numbers.
Do not incinerate. Depressurize container. Dispose of in accordance with Federal, State/Provincial, and Local regulations regarding pollution.
SECTION 14 — TRANSPORT INFORMATION
Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping
description for a particular mode of transport (ocean, air, etc.), does not indicate that the product is packaged suitably for that mode of
transport. All packaging must be reviewed for suitability prior to shipment, and compliance with the applicable regulations is the sole
responsibility of the person offering the product for transport.
US Ground (DOT)
May be classed as LTD. QTY. OR ORM-D
UN1950, AEROSOLS, 2.1, LIMITED QUANTITY, (ERG#126)
Canada (TDG)
May be classed as LTD. QTY. OR ORM-D
UN1950, AEROSOLS, CLASS 2.1, LIMITED QUANTITY, (ERG#126)
IMO
May be shipped as Limited Quantity
UN1950, AEROSOLS, CLASS 2.1, LIMITED QUANTITY, EmS F-D, S-U, ADR (D)
IATA/ICAO
UN1950, AEROSOLS, FLAMMABLE, 2.1, LIMITED QUANTITY
SECTION 15 — REGULATORY INFORMATION
SARA 313 (40 CFR 372.65C) SUPPLIER NOTIFICATION
CAS No. CHEMICAL/COMPOUND % by WT % Element
108-88-3 Toluene 18
100-41-4 Ethylbenzene 0.1
CALIFORNIA PROPOSITION 65
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
TSCA CERTIFICATION
All chemicals in this product are listed, or are exempt from listing, on the TSCA Inventory.
Item Numbers: 01405-2066 page Page 4 of 5

MSDS for #01405 - KRYLON SPRAY PAINT
Page 5 of 5
53569
SECTION 16 — OTHER INFORMATION
This product has been classified in accordance with the hazard criteria of the Canadian Controlled Products Regulations (CPR) and the
MSDS contains all of the information required by the CPR.
The above information pertains to this product as currently formulated, and is based on the information available at this time. Addition of reducers or other
additives to this product may substantially alter the composition and hazards of the product. Since conditions of use are outside our control, we make no
warranties, express or implied, and assume no liability in connection with any use of this information.
Item Numbers: 01405-2066 page Page 5 of 5