pneumatic grinders

PNEUMATIC PLIERS
Hand-held pliers for the use of cutting, angle forming and flattening, sealing operations, pressing,
mounting CLIC-, hose-, or spring clamps
Model
Pliers with trigger
48-181
48-271
48-271-1
48-271-2
48-401
48-551
48-601
Pliers with safety lever
48-281-2S
48-281-3S
48-381-2S
48-381-3S
48-451-2SV
48-451-3SV
48-451-4SV
Pliers for CLIC-/hoseclamps
48-381-3C6 (CLIC)
48-381-3C8 (CLIC)
48-381-2-7,5R (had.sponky)
48-381-4-10R (had.sponky)
48-451R (had.sponky)
48-451DR (had.sponky)
Pliers for spring-clamps
48-381-3FS
48-381-3FSR
48-451FS
48-451FSR
Squeeze force (N) 1 100 – 10 000 1 500 – 12 300 3 300 – 4 500 1 300 - 4000
Pliers insert, mounted Only for 48-271-1 Pliers inserts
- Optional Accessories
Yes
Yes
Length (mm)
With pliers insert
145 - 285
Without pliers insert
189 - 376
With pliers insert
164- 290
With pliers insert
Body diameter (mm)/in 27 – 60 (1-1/16“-2-3/8“) 36 – 55 (1-27/64“) 47 – 55 (1-27/32“) 47 – 55 (1-55/64“-2-3/16“)
Weight (kg/lbs) 0,12 – 1,56 (0,26-3,43) 0,5 – 1,4 (1,1-3,08) 0,55 – 1,2 (1,21-2,64) 0,85 – 1,1 (1,87-2,4)
I.D. of air inlet hose (mm) 6 (1/4“) 6 (1/4“) 6 (1/4“) 6 (1/4“)
Plier inserts for cutting are available in two designs:
• Standard execution for cutting metals. One insert side has an edge for cutting,
the other insert side is designed as a counter-holder. This eliminates a possible
crossing of the inserts and thus extensive wear of the insert joint. When
cutting soft, flowing materials, an overlapping of the inserts results in uneven
cuts or nicks.
• Special execution for cutting plastic materials. Both insert sides are equipped
with a cutting edge.
Squeeze Force 1 100 – 12 300 N