OWNERS MANUAL TSUNAMI 10 D

More documents

Recommendations

Info

Master slave With the right knob find the right menu position. With the up and down knobs select the desired value. One of the most important advantages of the digital is the data’s transfer. You can drive a speaker from another if you are in the correct configuration. This means that when you will move a value on one speaker the other entire one will change the same way. To do so, you need to place yourself in the following position. The first speaker must be placed in Master position. Use a stereo mini jack to get out of the remote connector of the first and master speaker and connect it to the input of the second and slave speaker . Link all the speakers you want to with a maximum of 99 speakers. All the others must be placed in slave position. When it is done, you can do the following test: Put your first left master speaker on the volume position and press the up and down knobs . You will hear the level modification. Take a look at the display of any of the other speakers, you will notice that the digits are changing the same way. Be careful !!: All the values need to start at the same level except if you want to implement a difference. For example: If the volume level is at -11 dB on the right slave speaker and that the level of the left master speaker is at -<strong>10</strong> dB, When you increase the volume of the master speaker of 2 dB it means that the level of the master will be at -12 dB and the level of the slave speaker will be at – 13 dB . It means that the difference remains. Why? Just because if you want to include a difference you still can do it, but do it when you do the first set up. What kinds of difference are interesting to implement? If the left speaker is closer to a corner than the right one you will maybe decrease the low tilt or shelf of 1 or 2 dB just to balance the bottom end of the two speakers. When the set up of the correct difference is done, you can make the adjustments of the entire system and you don’t need to care about this difference because it is already done. Take care: If you don’t know that there is a difference between the speakers you will keep this difference. This is why we installed a summary on the display when you power the speaker Connections: Of course you must link all the speakers you want to drive with the 3.5 mini stereo jack .
G. Curve selection With the right knob find the right menu position. With the up and down knobs select the desired value. For more flexibility and more efficiency, you can select 5 different presets. ( One at a time) - Flat - Academy : for film mixing - TV : for broadcast mixing. - Car & club : To simulate the feelings in a club or in a car. - Custom H. Room adjust With the right knob find the right menu position. With the up and down knobs select the desired value. The room ajust N°1 is flat as standard. The 4 next presets can be optimised following the wishes of 4 different sound engineers. Adjustment can only be done with PC software FAR module.
Page 1 and 2: FUNDAMENTAL ACOUSTIC RESEARCH OWNER
Page 3 and 4: B. Volume control Use the left and
Page 5 and 6: . D. Input selection : With the rig
Page 7: F. Channel A Channel B // Canal A C
Page 11 and 12: K. Connexions The digital active FA
Page 13: M. External dimensions Height Width

OWNERS MANUAL TSUNAMI 10 D

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?