Assembly Manual - Kettler USA

More documents

Recommendations

Info

<strong>Assembly</strong> Step 9 Jbar Important: Have two people complete Steps 9-13. With assistance, lift one table top onto the wheelbase; the legs will be facing outward. Have one person support the top while it is resting on the base while the other person completes assembly. Assemble crossbar to Jbars and support leg in the order shown. Note: a Jbar with safety lever should be assembled on the right side) and a Jbar without lever on the left side. The support leg is always assembled closest to the wheelbase. You may need to lower table slightly to line up the bolt holes. Do not fully tighten the bolts until both ends are assembled. Support Leg 2 Required m8x60 2 Required dia 25x8 Jbar A B C Support Leg D E F G 14
<strong>Assembly</strong> Step 10 Install plug into crossbar as shown. End view and side view shown 2 Required m6x5mm A B C 15
Page 1 and 2: Stockholm GT Table Tennis Table Mod
Page 3 and 4: Before Assembly (continued) General
Page 5 and 6: Package Contents (continued) Items
Page 7 and 8: Assembly Step 2 Install stemtubes t
Page 9 and 10: Assembly Step 4 Install locking whe
Page 11 and 12: Assembly Step 6 Install H-pads to a
Page 13: Assembly Step 7 Lock wheels. A B St
Page 17 and 18: Assembly Step 12 Bolt the Jbars to
Page 19 and 20: Assembly Step 14 Install handgrips
Page 21 and 22: Assembly Remove Film Remove protect
Page 23 and 24: Limited Warranty Ordering Spare Par
Page 25 and 26: Spare Parts Number Spare Part Numbe

Assembly Manual - Kettler USA

Create successful ePaper yourself

Delete template?

Save as template?