Operating Manual and Spare Parts Lists - Auras Pumpen
Operating Manual and Spare Parts Lists - Auras Pumpen
Operating Manual and Spare Parts Lists - Auras Pumpen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Useful Accessories<br />
6 Useful Accessories<br />
6.1 Base Suckers<br />
Our homepage at www.tauchpumpen.de provides a wide range of useful<br />
accessories. This chapter describes the installation of the most frequently used<br />
accessories:<br />
If you want to pump your cellar practically dry, for example, a base sucker from<br />
<strong>Auras</strong> can be used. The <strong>Auras</strong> base suckers pump the water practically to floor<br />
level.<br />
6.1.1 Installing the base sucker<br />
1. Disconnect the submersible pump from the power supply.<br />
2. Lay the submersible pump on its side.<br />
3. Loosen the three nuts in the base plate on the underside of the submersible<br />
pump.<br />
4. Remove the base plate.<br />
5. Mount the base sucker on the underside of the submersible pump. The collar<br />
must point to the air intake of the submersible pump.<br />
6. Tighten the three nuts in the base plate on the underside of the submersible<br />
pump.<br />
6.1.2 Using the base sucker<br />
Position the submersible pump with <strong>Auras</strong> base sucker installed at the lowest<br />
possible point of the area to be pumped.<br />
If you use a submersible pump with the <strong>Auras</strong> automatic system, switch to<br />
Continuous operation.<br />
Plug the power connector of the submersible pump in a power socket. The<br />
submersible pump starts its pumping operation.<br />
6.2 External Float Switch<br />
If your pump is not equipped with the <strong>Auras</strong> automatic system but you need an<br />
automatic operation option despite this, we recommend the float switch from <strong>Auras</strong>.<br />
6.2.1 Connecting the float switch<br />
NOTE<br />
Running dry could damage the submersible pump. Ensure the float switch switches<br />
the submersible pump off in good time. Fix the cable of the float switch so that the<br />
float hangs vertically down when the water level is low <strong>and</strong>, as a result, switches<br />
the pump off.<br />
Page 16