MODEL: B4030H - Shark Pressure Washers
MODEL: B4030H - Shark Pressure Washers
MODEL: B4030H - Shark Pressure Washers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
16 <strong>B4030H</strong> PRESSURE WASHER OPERATOR’S MANUAL<br />
TROUBLESHOOTING<br />
PROBLEM POSSIBLE CAUSE SOLUTION<br />
GAS ENGINE WILL<br />
NOT RUN<br />
Out of gas<br />
Fuel valve closed (if so equipped)<br />
Loose spark plug wire<br />
Choke or throttle set incorrectly<br />
Low engine oil level<br />
Engine ON/OFF switch in OFF<br />
position<br />
Replenish supply. Use only recommended<br />
fuels. Refer to Operation Section.<br />
Open valve.<br />
Reconnect.<br />
Refer to Operation Section.<br />
Replenish supply. Engine will not start or run if<br />
oil is low (on engines equipped with low oil<br />
protection).<br />
Place engine ON/OFF switch in ON position.<br />
Refer to provided gasoline engine manual for additional troubleshooting.<br />
PRESSURE WASHER<br />
RUNS BUT WON'T SPRAY<br />
LOW SPRAY PRESSURE<br />
AT PRESSURE NOZZLE<br />
UNEVEN SPRAY<br />
PATTERN<br />
Trigger of trigger gun released<br />
Water supply not turned on<br />
Clogged pressure nozzle<br />
Inadequate water supply<br />
Partially clogged or damaged<br />
pressure nozzle<br />
Air being drawn through detergent<br />
inlet line<br />
Engine throttle not in full throttle<br />
position<br />
Partially clogged or damaged<br />
pressure nozzle<br />
Squeeze trigger.<br />
Open water supply valve.<br />
Clean pressure nozzle opening.<br />
Fully open faucet. Check for kinked or<br />
damaged hose. Use 5/8 inch minimum hose.<br />
Check for debris clogging inlet screen.<br />
Clean or replace.<br />
Refill detergent container. Ensure that pickup<br />
screen is fully immersed.<br />
Place engine throttle in full throttle position.<br />
Clean or replace.<br />
<strong>Shark</strong> <strong>B4030H</strong> • Rev. 12/02