UNIGRAPH INTERNATIONAL INC. CANUTEC: (613) 996 ... - Spicers

UNI LITHOFOUNT 96 G R/O page 2
SECTION V - FIRE OR EXPLOSION HAZARDS
1. CONDITIONS OF FLAMMABILITY: This product is non flammable.
2. UPPER FLAMMABLE LIMIT %: Does not apply.
3. LOWER FLAMMABLE LIMIT %: Does not apply.
4. AUTO-IGNITION TEMPERATURE: Does not apply.
5. FLASH POINT: None.
6. HAZARDOUS COMBUSTION PRODUCTS: Oxides of carbon.
7. EXPLOSION DATA (sensitivity to mechanical impact): Stable.
8. EXPLOSION DATA (sensitivity to static discharge): Stable.
9. EXTINGUISHING MEDIA: Use a dry chemical, foam or carbon dioxide extinguisher.
SECTION VI - TOXICOLOGICAL PROPERTIES
l. EXPOSURE LIMIT: Refer to Section II.
2. TOXICOLOGICAL DATA: Refer to Section II.
3. CARCINOGENICITY: No ingredients are considered to be carcinogenic.
4. REPRODUCTIVE EFFECTS: This product has not been shown to be a reproductive
hazard.
5. MUTAGENICITY: This product has not been shown to cause damage to chromosomes.
6. TERATOGENICITY: This product has not been shown to produce birth defects.
7. SYNERGISTIC PRODUCTS: There is no data available.
SECTION VII - HEALTH HAZARD INFORMATION
1. INHALATION: Vapors may cause irritation to nose and throat.
2. SKIN CONTACT: Prolonged skin contact may cause slight irritation and itching.
3. EYE CONTACT: If splashed into eyes, it will cause strong irritation and burning.
4. INGESTION: Induce vomiting.
SECTION VIII - FIRST AID
1. INHALATION: Move victim to fresh air. Apply artificial respiration if breathing
has stopped.
2. SKIN CONTACT: Wash skin with mild soap and water.
3. EYE CONTACT: Hold eye lids open and rinse with water for 10 minutes. Contact a
physician if irritation persists.
4. INGESTION: Keep victim calm, administer oxygen if breathing is difficult.
Induce vomiting. Obtain medical attention immediately.
SECTION IX - PREVENTIVE MEASURES
1. VENTILATION: Insure adequate ventilation so that vapour concentration is
maintained below the threshold limit value.
2. SKIN PROTECTION: Wear rubber gloves.
3. EYE PROTECTION: Wear safety glasses.
4. HANDLING PROCEDURES AND EQUIPMENT: Avoid "splash-filling".