FINESSE A-RH (reduced height) - FINO
FINESSE A-RH (reduced height) - FINO
FINESSE A-RH (reduced height) - FINO
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1. The Articulator<br />
The articulator is the most important device for the fabrication of dental restorations.<br />
Thereby the function as well as the aesthetic of prosthetic work is closely related to the<br />
quality of the articulator that was used. Different types of restorations as well as the individual<br />
intraoral situation of the patient make high demands on the used articulators.<br />
ARCON and NON ARCON articulators: ARCON stands for articulator condyle. In<br />
ARCON articulators, the condylar balls are attached to the lower part of the articulator.<br />
In NON ARCON articulators they are in the upper part. Thus upper and lower parts of<br />
an articulator form a single unit. The condylar ball is design-related guided in the lower<br />
part of the articulator. This prevents malfunctions, which might be caused by an insufficient<br />
guidance while working.<br />
2. <strong>FINESSE</strong> Articulators<br />
The articulators <strong>FINESSE</strong> A, <strong>FINESSE</strong> A-<strong>RH</strong>, <strong>FINESSE</strong> B-<strong>RH</strong> and <strong>FINESSE</strong> TK have<br />
the same basic design. Upper and lower parts of the articulators are adjusted centrally to<br />
each other.<br />
Compared to the types <strong>FINESSE</strong> A und <strong>FINESSE</strong> TK the articulators <strong>FINESSE</strong> A-<strong>RH</strong><br />
and <strong>FINESSE</strong> B-<strong>RH</strong> have been <strong>reduced</strong> in total <strong>height</strong>. Thus the articulators with the<br />
additional designation <strong>RH</strong> correspond to the mounting <strong>height</strong>s of the earlier Artex ® -<br />
articulators. Because also the base as well as the Splitex ® plates of the Artex®articulators<br />
can be used, both systems are compatible.<br />
Upper and lower parts of the articulators are varnished. All screws are made of stainless<br />
steel. Delivery includes: <strong>FINESSE</strong> articulator complete with base plates, incisal support,<br />
incisal table and incisal guidance pin.<br />
The incisal guidance pin has a millimetre scale. The deepest groove corresponds to the<br />
zero position. (Upper and lower part of the articulator are parallel). The incisal guidance<br />
pin is locked with a screw. The boreholes at the incisal guidance pin serve for positioning<br />
the incisal pointer. The hole in the middle is used to position the incisal pointer. The<br />
tip of the incisal pointer marks the incisal point, which is the tip of the Bonwill triangle.<br />
In the <strong>FINESSE</strong> articulators it has an edge length of 110 mm.<br />
2