Industrial Grinders - Rainbow Precision Products, Inc.

Industrial Carbide Tool Grinders
500
• Precision built, for precision work, powered by 1/2 HP
reversible Baldor single or three-phase motor.
• Rigid construction and large 6204 bearings provide
vibration free operation.
• Large tool tables with protractor on each end to help
indicate angle.
• Protractor type tool support supplied, can be set into slot
on either tool table.
• Supplied with tool light on swivel mount may be placed
over either wheel.
• Water pot with spout and faucet, can be moved over
either wheel.
• Accommodates steel backed cup wheels 6” diameter, 1”
face, 1-1/4” center hole, sold separately.
• 500 supplied with 8-ft. 3-conductor power cord, 510
connected at factory for 208-230 volts, no cord.
Catalog
Number
Hp Voltage Phase Hz RPM
Shipping
Weight
Agency
Approvals
List
Price
500 1/2 115 1 60 3600 109 $1008
510 1/2 208-230/460 3 50/60 3000/3600 109 1008
NOTE: Designed to comply with OSHA standards under normal usage.
Wheels and Accessories for Carbide Tool Grinder
Catalog
Number
Description
Face
Width
Grit
List
Price
Shipping
Weight
C61 Silicone Carbide 1" 30 $88 3
C121 Silicone Carbide 1" 120 88 3
S46 Aluminum Oxide 1" 46 81 3
S61 Aluminum Oxide 1" 60 81 3
GA8 Wheel Dresser with Diamond NIB 97 3
GA7* Replacement diamond NIB for GA8 58 1
C61 GA8 GA7
NOTE: * 7/16" diameter, 1" long
When installing new wheels, check wheels for possible damage.
Do not use a damaged wheel.
Wear safety glasses. With new wheels installed and safety guards in place and operator standing away from front of
grinder, run grinder for approximately one minute before applying work.
8