Danfoss Linkâ¢ BR Boiler Relay - Danfoss.com

More documents

Recommendations

Info

Installation Guide Danfoss Link BR Wiring Danfoss Link BR Electronics N L 1 2 3 4 230 V AC Remove jumper if fitted Boiler ON/OFF terminals Note: Refer to boiler manufacturer’s manual for wiring connections to the boiler. Adding the device The process of adding the Danfoss Link BR to a system is performed on the Danfoss Link CC. Note that the Danfoss Link BR must be added as a Service Device. When adding, press and release the install button, and observe that the LED gives a fast green flash. If adding is successful the LED turns green permanently. For further information, see the Danfoss Link CC instruction manual. Note: If adding the Danfoss Link BR to the Danfoss Link CC is unsuccessful, make sure the right Danfoss Link CC software version is applied. Correct version: 2.3.27 or higher. 4 VIFZM202 © Danfoss 04/2012
Installation Guide Danfoss Link BR Configure Danfoss Link TM BR Select “Manage Devices” in “Rooms and Devices”. Select “Configure Device”. Select Device to configure Press “Configure Heating” to bring up the heating configuration, which will show the current heating preferences and allow them to be edited by pressing the buttons. VIFZM202 © Danfoss 04/2012 5
Page 1 and 2: MAKING MODERN LIVING POSSIBLE Danfo
Page 3: Installation Guide Danfoss Link BR
Page 7 and 8: Installation Guide Danfoss Link BR

Danfoss Linkâ¢ BR Boiler Relay - Danfoss.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Danfoss Linkâ¢ BR Boiler Relay - Danfoss.com