TM 9-2320-211-34-2-1 - JATONKAM35s HOME ON THE WEB

Do not dry bearings with compressed air.
serious injury to personnel.
Transfer input shaft assembly is heavy.
injury.
WARNING - Cont
Spinning bearings may explode and cause
Be careful when working on it to avoid
When working on front axle assembly, weight of vehicle must be supported by floor
jacks or motor vehicle trestles at all times. Do not attempt to support weight of
truck on hydraulic jack.
Do not use a wire brush or compressed air to clean clutch disk facings. There may
be asbestos dust on the disk facings which can be dangerous to your health if you
breathe it in.
Use extreme care when handling heated ring gear to prevent being injured.
b