Compression Fittings - List Price - Peak Pipe Systems
Compression Fittings - List Price - Peak Pipe Systems
Compression Fittings - List Price - Peak Pipe Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
39<br />
Fitting Instructions<br />
ADAPTOR SET FOR TABLE ‘X’ AND ‘Y’ COPPER<br />
Remove nut from fitting and<br />
discard white split ring. Except<br />
35, 42 & 54mm fittings, where<br />
white split ring is used as<br />
spacer. Push black rubber seal<br />
into fitting body & assemble<br />
components in the nut in the<br />
order show above<br />
Replace nut onto fitting body<br />
without tightening. Mark pipe<br />
at ‘X’ in order that pipe end<br />
reaches flange on body of<br />
fitting ‘Y’, as shown above.<br />
Recommended Assembly<br />
Tool 7990 - page 35<br />
Push pipe through nut adaptor<br />
and metal ring, into body of<br />
fitting to ‘X’ mark on pipe as<br />
show. Wrench tighten nut on<br />
to body firmly using Plasson<br />
spanners or suitable wrenches.<br />
The metal grip ring must be<br />
replaced with new if adaptor is<br />
re-used.<br />
Remove any unsound material adhering to the pipe.<br />
Cut and de-burr pipe as necessary. Slide the Plass4 fitting<br />
end onto the pipe until it reaches the internal fins and a<br />
resistance point it felt.<br />
Important: Do not force pipe end past the resistance<br />
point before tightening as this may impair the joint.<br />
Tighten the nut against the body: Final tightening to be<br />
done with Plasson wrench or similar.<br />
Assemble the Metric P.E. joint as per the standard<br />
fitting, ensure the metal teeth are located in the grip ring,<br />
and pipe end does not pass the location fins in the body.<br />
DEDICATED PE TO COPPER Part Number 3510<br />
1. Cut copper pipe square and remove all burrs<br />
and sharp edges.<br />
2. Twist the pipe into the fitting through the<br />
rubber o-ring to the pipe stop.<br />
3. Wrench tighten nut onto body firmly using<br />
Plasson spanners or suitable wrenches.<br />
4. The metal grip ring must be replaced with new<br />
if adaptor is reused.<br />
NB: For copper pipe systems only.<br />
plasson.co.uk<br />
sales@plasson.co.uk