FAG SNV Plummer Blocks - Reliance Bearing

Mounting
Mounting sequence for SNV housings
with the felt seal FSV (fig. 11)
11: Mounting of SNV housings with felt seals FSV
1. Clean and check support surface.
2. Lock housing base into position.
3. Insert O rings into the grooves of
housing base.
4. Place each half of the adapter with
oil-soaked felt strip on the O ring in
the grooves of housing base.
5. Mount bearing on shaft and fill its
cavities with some of the grease quantity
according to table 5.
6. Insert shaft with mounted bearing in
housing base. Insert both locating
rings for locating bearing. The floating
bearing should be positioned in
the housing centre. In the case of
housings closed at one end insert only
one adapter with felt strip and, at the
opposite side, the cover DKV into the
housing grooves.
7. Align housing base and tighten
fastening bolts in housing foot with
the recommended tightening torque,
table 13.
8. Distribute equally the remaining
bearing grease (point 5) between the
housing top and base.
9. Insert O ring and adapter with oilsoaked
felt strip into the grooves of
housing top.
10. Mount housing top and tighten fastening
bolts with the recommended
tightening torque, table 13.
FAG · 14