Instruction Manual - Fivestar Tools Co., Ltd

More documents

Recommendations

Info

3) Punching Version a) Pull out the latch and open the lock-hook, settle the adapter. (as the illustration below to preparing working)
) Close the lock-hook, and press the button to return the piston. c) Select the suitable punch die with stud and settle onto the head for punching. d) Dill a lead hole at the center point of the hole marked and measured. e) Thread the Threaded Stud into the punch head. f) The spacer is to be used with all punch and dies that are used to protect the head. Slide the spacer down onto the threaded stud, and then slide the die onto the Threaded Stud so that it sits flat on the spacer. After that slide the work piece with the drilled hole down onto the die Thread the punch onto the work piece as tightly as possible. g) Switch the trigger to start punching, keep pressing until the punch has punched through the work piece,. The tool will retract automatically after punching. h) Press the retract button in case of an incorrect operation. Capacity and Draw Stud Selection Guide Draw Studs and Standard Round Knockout Punches (Type D) Accessories 22.5mm 28.5mm 34.6mm 43.2mm 49.6mm 61.5mm 7/16”Draw Stud ▲ +spacer 3/4”Draw Stud ▲ ▲ ▲ +spacer 3/4”Draw Stud ▲ ▲
Page 1 and 2: Instruction Manual Battery multi-fu
Page 3 and 4: GENERAL SAFETY RULES TO WORK IN SAF
Page 5 and 6: 17. The built-in safety valve goes
Page 7 and 8: 3. Function description MCU -automa
Page 9: 2. Usage of the tool CAUTION Make s
Page 13: LIMITED ONE YEAR WARRANTY We make e

Instruction Manual - Fivestar Tools Co., Ltd

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?