Instruction Manual - Fivestar Tools Co., Ltd

More documents

Recommendations

Info

make die according to detail requirements. 2. Description of components Table 1 Code Description Function 1 Latch For locking the head 2 Retaining clips For locking/unlocking the dies/blade holder 3 LED indicator For indicating the operating condition and battery discharging situation. 4 Retract button For manual retracting the piston in case of an incorrect operation. 5 Trigger For starting operation 6 Battery lock For locking/unlocking the battery. 7 Battery For supplying power, rechargeable Li-ion (18V). 8 Stud For connecting die during operation 9 Punch & Die For punching 10 Adaptor For assisting punching operation 11 Die holder For fixing crimping die 12 Retaining clips For locking/unlocking the crimping die 13 Die For crimping, interchangeable crimping die 14 Blade For cable cutting
3. Function description MCU –automatically detect the pressure during operation and provide security protect, shut off the motor and reset automatically after operation. Auto reset –Release the pressure automatically, retract the piston to the starting position when reach the max output. Manual reset –Can retract the piston to the starting positioning in case of an incorrect operation. The unit is equipped with a double piston pump which is characterized by a rapid approach of the die towards the connector and a slow crimping motion. The head can be smoothly turned by 360°around the longitudinal axis in order to gain better access to tight corners and other difficult working areas. One significant sound will be heard and a red display flashes if any error occurs. The whole tool is controlled by one trigger. This results in an easy handling and a better grip compared to a two button operation. Li-ion batteries do neither have a memory effect nor self-discharge. Even after long periods of non-operation the tool is always ready to operate. In addition we see a lower power weight ration with 50% more capacity and shorter charging cycles compare to NIMH batteries. A temperature sensor makes the tool stop working automatically when the temperature over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work until the temperature reduce to the normal. Series Instruction What it means No. 1 ★★ Self-checking Self-checking to assure everything is ok 2 ★-5sec Overload Hydraulic system may damage and need check immediately 3 ★★★ ●●● Charging Lacking power and need charging signal 4 ★-5sec ●-sec Power lacking warning No power and need charging immediately 5 ★★★ ★ ●●●● Temperature warning Temperature too high and need to cool down 6 ★★★ ★★ ●●●● ● No pressure Motor pressure working but without
Page 1 and 2: Instruction Manual Battery multi-fu
Page 3 and 4: GENERAL SAFETY RULES TO WORK IN SAF
Page 5: 17. The built-in safety valve goes
Page 9 and 10: 2. Usage of the tool CAUTION Make s
Page 11 and 12: ) Close the lock-hook, and press th
Page 13: LIMITED ONE YEAR WARRANTY We make e

Instruction Manual - Fivestar Tools Co., Ltd

Create successful ePaper yourself

Delete template?

Save as template?