table of contents - Robitronic

More documents

Recommendations

Info

STEP G-05 Air Filter Installation BAG G 1 2 STEP G-06 Pipe Mount Assembly x 1 8-32 x 1/8” A9165 Pipe Wire Mount A9165 Pipe Wire Trim pipe mount in small increments as needed to mount pipe. Ensure that the wire clears all steering components. x 1 8-32 x 3/8” 29
STEP G-07 Engine Installation BAG G • • • • Adjust the Gear mesh between the Clutch Bell and the Spur Gear by sliding the Engine Mounts in the slots of the Chassis. In order to function properly, the Gears should be as close as possilbe, but still have a small amount of backlash (space between the Gear teeth). Place a piece of paper between the Clutch Bell Gear and Spur Gear, Slide the engine sideways until the paper is pinched between the Gears and Tighten the engine mount Screws. This will give a small amount of space between the gears. You should be able to rock one Gear back and forth slightly while holding the other one steady. Be sure to check the Gear mesh all the way around the Spur gear. Once the engine alignment and Gear mesh are correct, tighten all of the Screws. Re-check the Gear mesh after all the Screws are tight to ensure the Engine Mounts did not move. x 1 Body Clip Supplied with pipe (Not included) 2 1 x 1 x 4 #8 Countersink x 4 8-32 x 1/2” STEP G-08 Fuel Tube/Completed Engine Assy. A9316 Fuel Line Clip 30
Page 2 and 3: STEP I-01 Intro to the 8IGHT Manual
Page 4 and 5: BAG A STEP A-01 Steering Link Asse
Page 6 and 7: STEP B-01 Ring Gear Assembly BAG B
Page 8 and 9: STEP B-06 Spindle/Carrier Assembly
Page 10 and 11: STEP B-10 Front Camber Link Assembl
Page 12 and 13: STEP C-01 Ring Gear Assembly BAG C
Page 14 and 15: STEP C-08 Brake Caliper Assembly BA
Page 16 and 17: STEP D-01 Ring Gear Assembly BAG D
Page 18 and 19: STEP D-06 BAG D Rear Suspension Arm
Page 20 and 21: STEP D-10 Tie Rod Installation BAG
Page 22 and 23: • • • • • • • • •
Page 24 and 25: STEP E-04 Rear Shock Installation B
Page 26 and 27: STEP F-03 Servo Chart/Wiring Diagra
Page 28 and 29: STEP F-07 Receiver Battery Door BAG
Page 30 and 31: STEP G-01 Clutch Assembly BAG G A91
Page 34 and 35: STEP H-01 Tire Mounting BAG H 1 2 A
Page 36 and 37: STEP H-05 Body Painting & Trimming
Page 38 and 39: STEP H-07 Completed Chassis Assembl
Page 40 and 41: SETUP GUIDE TIPS AND HINTS FROM THE
Page 42 and 43: 39 Setup Notes: ___________________
Page 44 and 45: Name: Standard Kit KIT SETUP Date:

table of contents - Robitronic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?